CONTROLS AND INSTRUMENTS
ENGINE ELECTRONIC CONTROL UNIT
John Deere Engine Electronic Control Unit
The John Deere Electronic Control Unit (ECU) is capable of detecting, storing, and reacting
to abnormal engine operating conditions or faults. The presence of a fault is reported to the
operator through the amber colored lamp (A) located on the dash. Depending upon the severity
of the engine fault detected, the ECU may take steps to minimize engine damage by reducing
power output. Faults are also stored in the ECU and can be accessed by service personnel later.
These stored faults can be viewed using the same amber colored lamp (A) located on the
machine's dash using a system known as Blink Code Diagnostics. Details and procedures
regarding ECU fault detection, engine protection, and blink code diagnostics are outlined below.
Engine Protection
When the engine is in operation, and the engine ECU detects a Warning Condition the amber
light (A) on the dash will begin flashing. A Warning Condition is an engine fault in which a
critical monitored engine parameter goes beyond normal operating values. If the engine
operating conditions are not improved, or become more extreme, the Warning Fault may become
a Shutdown Fault. At this point, the amber light (A) on the dash will stay lit and the engine ECU
may begin a sequence of power reduction. The operator is responsible for shutting down the
engine to prevent further damage to the engine.
The engine ECU will not detect all engine problems. The engine protection feature is not a
substitute for routine engine maintenance. Normal machinery operating procedures should be
adhered to.
(1.22x1.22x1.22 METERS). LOAD
STANDARD FORK FRAME.
CAPACITIES AT 24 INCH
(.61 METERS ) LOAD CENTER WITH
REAR AXLE LOCK-UP ENGAGED.
RATED LI FT CAP ACITIES ARE WITH :
CHLORIDE SOLUTION FILLED TIRES
OR OPTIONAL F OAM FILLED TIRES.
P ROPERLY INF LATED CALCIUM
S URFACE WITH UNDAMAGED,
MACHINE ON A FIRM, LEVEL
(A) LETTER VISIBLE = 6,000 LBS
LAST F ULLY VISIBLE LETTER
( B) LETTER VISI BLE = 4,000 LBS
LOAD LIMITS / HORIZONTAL BOOM
(D) LETTER VISIBLE = 2,000 LBS
(C) LETTER VIS IBLE = 3,000 LBS
P/N 3-1483
4
(1.22)
METER
FEET
RETRACTED = 8,000 LBS
(9.76)
28
(8.54)
24
32
20
(7.32)
0
(6.10)
(7.32)
(6.10)
(8.54)
20
24
28
(2.44)
8
(1.22)
4
0
(4.88)
(3.66)
20
16
12
HEATER
HEADLIGHT
PUMP OFF
HYDRAULICS
WIPER
AUXILIARY
LEFT
STABILIZER
RIGHT
STABILIZER
CONTROL
SWAY
P.O. BOX 790
BARAGA, MICHIGAN 49908
FAX 906-353-7543
PHONE 906-353-6675
STABILITY TESTS USING STANDARD
MANUFACTURER'S RECOMMENDED
CAPACITY IS PER ANSI B56.6
455 NORTH SUPERIOR AVENUE
!"#"$
& ' ()*"#+
HOMOGENEOUS CUBES 4x4x4 FT.
FEET
METER
48
(14.64)
(12.20)
(10.98)
36
40
(13.42)
44
(6.10)
(4.88)
20
(7.32)
24
(6.10)
(8.54)
28
16
(3.66)
12
16
(4.88)
20
(3.66)
12
BRAKE ON
BLINK CODE
BLI NK CODE ENABLE
WARNING / STOP ENGINE
3 - 12
A
B
C
Содержание GTH-1048
