Genie GS-2668 RT, Руководство по обслуживанию

Страница: 71 / 184

Section 4 • Repair Procedures
REV B
June 2007
Part No. 112657 GS-2668 RT • GS-3268 RT 4 - 9
34 Remove the cables from the lower cable tray.
Lay the cables off to the side of the machine.
35 Remove the mounting fasteners from the lower
cable tray mounting bracket on the number 2
center pivot pin (index #7) at the engine side of
the machine.
36 Remove the mounting fasteners from the lower
cable tray supports at both ends of the lower
cable tray.
37 Remove the lower cable tray from the machine.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
38 Attach a lifting strap from an overhead crane to
the lug on the rod end of the lift cylinder.
39 Remove the pin retaining fasteners from the
cylinder rod-end pivot pin (index #5). Use a soft
metal drift to remove the pin.
Crushing hazard. The cylinder
could fall if not properly supported
when the pin is removed.
40 Lower the cylinder onto the number 1 center
pivot pin (index #9).
41 Remove the external snap rings from the
number 3 pivot pin (index #6) at the steer end.
42 Use a soft metal drift to remove the number 3
pivot pin (index #6) at the steer end. Remove
the number 3 inner arm (index #16) from the
machine.
Crushing hazard. The number 3
inner arm (index #16) could
become unbalanced and fall if not
properly supported when removed
from the machine.
43 Attach a lifting strap from an overhead crane to
the number 2 outer arm (index #20) at the
ground controls side.
44 Support the number 2 inner arm (index #19)
with a second overhead crane at the non-steer
end.
45 Remove the external snap rings from the
number 2 center pivot pin (index #7) at the
ground controls side.
46 Use a soft metal drift to remove the number 2
center pivot pin (index #7) at the ground
controls side.
47 Remove the external snap rings from the
number 2 pivot pin (index #21) at the non steer
end.
48 Use a soft metal drift to tap the number 2 pivot
pin (index #21) halfway out at the non-steer end
of the machine. Remove the number 2 outer
arm (index #20) at the ground controls side
from the machine.
Crushing hazard. The number 2
outer arm (index #20) at the
ground controls side could
become unbalanced and fall if not
properly supported when removed
from the machine.
49 Attach a lifting strap from an overhead crane to
the number 2 outer arm (index #20) at the
engine side.
50 Remove the external snap rings from the
number 2 center pivot pin (index #7) at the
engine side.
51 Use a soft metal drift to remove the number 2
center pivot pin (index #7) at the engine side.
SCISSOR COMPONENTS