Genie Genie Z13505-101, Руководство по обслуживанию и ремонту

Страница: 88 / 253

Service and Repair Manual October 2016
Boom Components
76 ZX-135/70 Part No. 1268558
20 At the ground controls, press the plus button
or minus button to adjust the display to the
exact value shown on the digital level and
press the
enter button.
Note: If the measured angle already matches the
angle shown on the display at the ground controls,
press the
plus button or minus button to change
the angle and then change back to the measured
value. The system must detect a change in
displayed value to record the calibrated value.
21 Press and hold a function enable/speed select
button and the primary boom up button until
the digital level displays 40 degrees.
22 At the ground controls, press the plus button
or minus button to adjust the display to the
exact value shown on the digital level and
press the
enter button.
Note: If the measured angle already matches the
angle shown on the display at the ground controls,
press the
plus button or minus button to change
the angle and then change back to the measured
value. The system must detect a change in
displayed value to record the calibrated value.
23 Press and hold a function enable/speed select
button and the primary boom up button until
the primary boom is fully raised. The boom is
fully raised when the cylinder is fully extended
and the boom stops moving. The angle will be
70 degrees.
24 At the ground controls, press the plus button
or minus button to adjust the display to the
exact value shown on the digital level and
press the
enter button.
Note: If the measured angle already matches the
angle shown on the display at the ground controls,
press the
plus button or minus button to change
the angle and then change back to the measured
value. The system must detect a change in
displayed value to record the calibrated value.
25 Press and hold the engine start button for
approximately 5 seconds to shut off the engine
and to save the calibration settings.
Note: Do not turn the engine off with the key switch
or red Emergency Stop button or all calibration
points or values will not be saved.
26 Press the enter or previous button on the
LCD screen until EXIT is displayed.
27 Press the plus button to select YES, then
press the enter button to accept.
28 Turn the key back to the run position and
remove the key from the bypass/recovery key
switch. Insert the key into the main key switch
and turn it to ground controls.
Note: Be sure that the bypass/recovery key switch
is in the run position before attempting to operate
the machine.
29 Wait approximately 20 seconds and turn the
machine off by pressing the red Emergency
Stop button in.
30 Remove the fastener that was temporarily
installed. Close the control box door and install
the door retaining fasteners.
Note: When the control box door is closed, the
calibration toggle switch is automatically activated
to exit out of calibration mode.
31 Pull out the red Emergency Stop button. Start
the engine and lower the boom to the stowed
position. Be sure there are no calibration faults
shown on the display.
32 Perform a primary boom angle test. Refer to
Maintenance Procedure in the appropriate
Service or Maintenance Manual,
Test the
Primary Boom Angle Sensor .