Genicom microLaser 210, Руководство пользователя

Страница: 175 / 212

Mar 00 Genicom Publication No. GEG-99054
microLaser 210 User Guide 9-3
Installing the Offset Catch Tray
Major Components of the Offset Catch Tray
The following illustration shows the major components of the offset catch tray:.
Figure 9-2: Offset Catch Tray Major Components.
Installing the Offset Catch Tray
Before installing the offset catch tray, remove it from its packaging and verify that you have received
an offset catch tray and that it is in good condition. If any part of the offset catch tray is missing or
damaged, contact your dealer.
Throughout this procedure, the different sides of the printer are referred to as front, rear, left, and
right. The front of the printer is the side that holds the control panel. The left and right sides are
those to the left and right, respectively, of a person facing the front of the printer.
Use the following procedure to install the offset catch tray:
1. Remove any cardboard inserts or packing tape from the interior and exterior of the offset
catch tray.
2. Turn the printer off by pressing [ O ] on the power switch on the front left of the printer, and
disconnect the power cord from the AC outlet.
Output Tray
Paper Guide
Fitting
Paper Stop