Genicom 38 Series, Краткое руководство пользователя

Страница: 15 / 179

Quick Reference Guide GEK-89604 14
Make sure the exit rollers engage the form.
Print lines may be skewed if the exit rollers do not
engage the edges of the form. Open the top cover
and look at the form. If the exit rollers do not
engage the edges of the form, press the
PARK/PATH key to park the form, and pull the
home-position tractor locking lever forward, adjust
the tractor position so that the edge of the paper
lines up with “0” on the position guide label behind
the tractor.
Line Registration on the First Form
Precise line registration depends on the form being
fully engaged by the exit rollers. The printer is not
guaranteed to hold specified line registration for
the first inch of the first form. This also applies to
cut sheets loaded from the manual paper path.
If a form did not load.
Check the paper path selection. Make sure that the
form is loaded in the tractors that correspond to
the paper path selection. If paper is jammed, take
the paper out of the tractors and pull the jammed
paper out of the printer from the tractor side and
try again with a fresh form.
If a form is loaded, the fault light should be out.
If it is not, press the CLEAR key. When the printer
is shipped, it is configured so that a paper-out
fault is automatically cleared when a form is
loaded. There is a software option that can be set
so the CLEAR key must be pressed to clear the
fault, see Chapter 2 of the
3870 User’s Manual
.
Exit Roller
Exit Rollers
Foam
Exit Rollers Engagement