9
English
OPERATION
WARNING:
Always check that the power supply corresponds to the
voltage on the rating name plate.
WARNING:
Always be sure that the tool is switched off and unplugged
before adjusting, adding accessories, or checking a function on the tool.
Switch Action
WARNING:
Before plugging in the tool, always check to see that the tool
is switched off.
The switch can be locked in "ON" position for ease of operator comfort during extended use. Apply
caution when locking tool in "ON" position and maintain a firm grasp on the tool. Your sander is
equipped with a clear, flexible plastic boot that covers the "ON/OFF" switch; this is referred to as a
"dust-protected switch". It is not uncommon for sanders to collect large amounts of airborne sawdust
in the switch area, which, if not cleared out, may cause the switch to become non-functional. The
dust protected switch, on the other hand, can not accumulate dust in the switch area.
To start the sander,
press down the "I" (ON) side of the switch.
To stop the sander,
press down the "O" (OFF) side of the switch
.
Installing and Removing Abrasive Paper:
WARNING:
Always be sure that the tool is switched off and unplugged
before performing any work on the tool.
Your sander is designed to use 1/4 sized sanding sheets, measuring 4 1/2" X 5 1/2" in size. You can
purchase abrasive paper pre-cut to the 1/4 sheet size or you can make your own. Cut a standard, full
sized sheet (9"X11") of abrasive paper into 4 equal sized pieces, 4 1/2" x 5 1/2". Cut a 1/2 sheet of
abrasive paper into two 4 1/2" x 5 1/2" pieces.
Once you have prepared an adequate supply of 1/4 sheet sized abrasive paper in various grit sizes and
you’ve ensured the tool is unplugged from the power source, you install the paper on the sander as
follows:
Open the front paper clamp by releasing the clamp lever (left side) and inserting the 4 1/2" edge of the
abrasive paper under paper clamp until it hits the built-in stop. Center the paper and align the edges
parallel to the pad, then re-secure the clamp lever to secure the paper.
Remove the dust collection bag and stretch the paper tightly across the sanding pad. Release the rear
paper clamp lever; insert the remaining paper edge under the clamp; keeping the paper tight against
the sanding pad, then re-secure the rear paper clamp.
Reinstall the dust collection bag. (HINT: Inserting the abrasive paper ends under the clamps can
be made easier by pre-bending or softening these edges first. To soften the edges, repeatedly pull
them over a 90° table or similar edge until they become pliable and easy to fold. The pre-bending or
softening technique is especially useful with the larger grits and their stiffer abrasive papers, 36 to
80Grit.)
Paper Punch Plate
Your sander is equipped with a special sanding pad and dual purpose fan, giving it dust collection
capability. By having dust collection capability, you are able to minimize the amount of ambient dust in
the air around you, substantially reduce messy dust on the workpiece & work area, and increase the
surface finish quality produced by the sander.
