Genesis GJS450, Руководство оператора

Страница: 9 / 40

9
English
OPErATiOn
WArning:
Always check that the power supply corresponds to the
voltage on the rating name plate.
SWITCH ACTION
WArning:
Always be sure that the tool is switched off and unplugged
before adjusting or checking function on the tool. Switch can be locked in
“On” position for ease of operator comfort during extended use. Use caution
when locking tool in “On” position and maintain a firm grasp on the tool.
your jig saw is equipped with an “ON/Off” switch trigger which is operated by squeezing
or releasing.
•
To start the tool
, simply pull the switch trigger.
•
To stop the tool
, release the switch trigger.
Using with the “Lock-On” button:
your jig saw is also equipped with a “Lock-On” button, located on the left side of the saw's
handle just above the switch trigger. using the “Lock-On” button allows the saw to be run
continuously without the operator having to constantly apply pressure to the switch trigger.
•
To start the tool and run the tool continuously
, pull the switch trigger then push in
the “Lock-On” button and release the switch trigger.
•
To unlock the switch
, pull the switch trigger fully and release it.
WArning:
if the “Lock-On” button is continuously being depressed, the
trigger cannot be released.
TO INSTALL OR REMOVE THE SAW BLADE
WArning:
Always be sure that the tool is switched off and unplugged
before adjusting, adding accessories, or checking a function on the tool
CAUTiOn:
Always clean out all chips or foreign matter adhering to the blade
and/or blade holder. Failure to do so may cause insufficient tightening of the
blade, resulting in a serious personal injury. Do not touch the blade or the
workpiece immediately after operation; they may be extremely hot and could
burn your skin. Always secure the blade firmly. insufficient tightening of the
blade may cause blade breakage or serious personal injury.
To install the blade:
1. Position the chip shield up to allow access to the Blade
Collet.
2. Open the Blade Collet by rotating the (Spring Loaded) Collet
Lever clockwise.
3. With the blade teeth facing forward, insert the blade into the
Blade Collet as far as it will go.
4. Check to make sure the back edge of the blade is positioned
properly in the groove of the roller guide.
5. Release the Collet Lever. The blade should now secured in
the Blade Collet.
6. Lower the chip shield completely.
FIG 2
BLADE COLLET
COLLET LEVER
ROLLER GUIDE