Genesis GenWatch3 GW RSP25, Книга

Страница: 19 / 30

19
600- 2.16.15 -EE.1
•
Control Channels # RX/TX : Control channels used on this system.
Control channel values must be entered in hertz. Most control channels are
shown in megahertz, so you may need to multiply the number by 1 million
to determine the hertz value. All eight control channels must be provided.
Please note:
o
If your system uses only one control channel, repeat that control
channel value for each channel; enter it in all four positions of the
same type (RX or TX).
o
If your system uses only two control channels, then repeat the
second control channel value in the third and fourth positions.
o
If your system uses only three control channels, then repeat the
third control channel value in the fourth position.
Control Channel RX is for the frequency that is receiving control channel activity. Control
Channel TX is for the frequency transmitting (sending) control channel activity.
Changing the RX values will set their respective TX value to the values’ expected RX values.
This feature speeds setup for non-UHF/VHF connections.
Figure 2.1 – Settings for Millennium Connection
Non-APX Millennium connections require the Remote Access Connection Manager service.
If this service is disabled, it will not be possible to connect to a Millennium device.