54
Figure 51:
HTTP - Job Editor: RCCMD TRAP
Because the CS121 adapter plays an active roll when executing its actions “Message”,
“Shutdown” and “Command” (that is to say the CS121 -adapter sends an RCCMD-signal to an
RCCMD client), it is necessary, to enter the IP-address in parameter 1, and the port number of
the RCCMD client in parameter 2 (default port is 6003). Additionally, the RCCMD client must
either be pre-configured with absolutely no sender filter or should be pre-configured with the
IP-addresses of the particular UPSMAN servers (like UPSMAN, CS121 or other RCCMD
compatible sender) that are to function as recognized senders. These configurations take
place when installing the RCCMD client service. Further details are in the RCCMD software
documentation.
Attention:
At the function RCCMD Command it is required to configure a job for every single
client. It is not possible to request several clients/IP-addresses in one job to execute a
command.
RCCMD also includes the feature “RCCMD Trap”. RCCMD Trap is a method for sending
information to the RCCMD stations which have been applied to the CS121. RCCMD Traps
invokes messages at all RCCMD stations. Because of RCCMD plays an active roll in this
mode no receiver information is to be entered in the parameters of this job (see also following
sections). It is condition to enable the RCCMD Trap control box in the menu “Network &
Security Settings”.
The CS121-adapter uses the parameter-based RCCMD Version 2, which can execute
different actions on the same TCP channel. RCCMD Version 1 clients can only execute one
action (shutdown file execution as default, so any RCCMD signal which is transmitted to an
RCCMD client V1 will cause a shutdown of this server ) RCCMD Version 3 is capable to
handle also redundant UPS installations (eg. PC with 2 power supplies and 2 UPS).
Note:
For all 3 RCCMD event functions a list of the user configured RCCMD
receivers appear in every RCCMD event.
The amount of RCCMD clients is limited and dependent of the size of the RAM. 50 RCCMD
clients per CS121 are guaranteed. If you need more than 50 clients to reach, we recommend
to use RCCMD relays (see chapter 5.1.4). However it is only possible to execute 50 clients at
the same time, meaning that the first 50 RCCMD clients are executed followed by the next 50
etc. We recommend to change the timing parmeters of the RCCMD-jobs that always less than
50 commands are transmitted at the same time. We also recommend to use an RCCMD client
as Relaystation if you want to shutdown more than 50 computers from a single CS121. (see
section 6.1.1 RCCMD with SSL for Windows
Содержание CS121BL
Страница 2: ......
Страница 68: ...66 Figure 72 HTTP Status Page Socomec Transfer Switch Figure 73 HTTP Status Page Eaton Transfer Switch ...
Страница 71: ...69 Figure 76 CS121 FTP Access Figure 77 CS121 FTP Context Menu Figure 78 CS121 FTP Folders ...
Страница 107: ...105 Figure 135 Internet Explorer LAN Proxy Einstellungen ...