General Slicing / Red Goat Disposers
SHARPENING THE KNIFE (SUPPLEMENT)
FOR
MODEL SM-12A SLICER
1. SHUT OFF and unplug slicer.
2. Turn regulator knob to Zero ("O").
3. Clean knife with hot soapy water. (See disassembly instructions, Page 2)
4. PULL UP (DO NOT TURN) sharpener using black knob. (Fig.11).
5. Rotate sharpener clockwise ¼ turn and remove (lift straight up) from shaft.
6. Inspect sharpener stones to be:
a. Free of cracks or chips; if cracked or broken replace stones.
b. Clean; no grease or food.
c. Both stones rotate and move back and forth freely against springs.
7. If sharpener stones need cleaning, use provided brass brush, wash in hot soapy water and dry.
8.
Set sharpener back on shaft and rotate further clockwise (180° from original position) and push
down until stones touch knife. (Fig.12)
9.
In this position, Cap sharpener down slightly until pink stone makes firm contact with knife at the
pre-set angle. (Fig. 12)
10. Plug-in and turn on slicer, KEEPING HANDS AND FINGERS AWAY FROM KNIFE.
11.
Let pink stone grind knife for approximately 5 seconds. Be sure pink stone is rotating. If not,
shut off slicer, remove sharpener and lubricate stone shaft with provided oil.
12.
Push-in on deburring (blue/gray) stone knob (No. 11, Fig. 12) for 2-3 seconds to "knock-off" burr
on front edge of knife. Be sure that blue/gray stone is rotating. If not, shut off slicer, remove
sharpener and lubricate stone shaft with provided oil.
13. When sharpening is complete, shut off slicer while stones are in sharpening position.
14. Remove sharpener by pulling up on black knob and rotating it ¼ turn counter-clockwise.
15. ALWAYS SHUT-OFF slicer when inspecting knife cutting edge.
16. CAUTION: NEVER TOUCH rotating knife; will cause severe cuts to fingers and hands.
17. Clean off filings from knife, sharpener and slicer surfaces.
18. Replace sharpener to its storage position by:
a. Hold in position as shown in Fig. 5, page 3.
b. Set sharpener on to shaft and rotate counterclockwise until sharpener slides-down on shaft and
into storage position.
Содержание SM 12
Страница 10: ......
