General MDF15, Руководство оператора

Страница: 28 / 42

MDF15-0240 be installed in the proper location within
the cylinder head and the PN MDF15-0130 or MDF35-
0130 distribution gauge be reinstalled in the proper
position to allow the compressed air to properly flow
through the Long Reach Air Tool.
DISASSEMBLY OF THE THROTTLE CONTROL
VALVE FOR GENERAL MAINTENANCE AND/OR
REPAIR PURPOSES.
Application: All models.
Tools Required:
1 each, large flat blade screwdriver.
Parts Required:
1 each, MDF15-0300 valve spool (if required).
1 each, MDF15-0260 O ring (if required).
1 each, PN MDF15-0270 O ring (if required).
1 each, PN MDF15-0290 spring (if required).
1 each, container of pipe joint compound.
1 each, container of pneumatic tool lubrication oil.
1) Disconnect the Long Reach Air Tool from the
compressed air source and the Air Caddy (if so
equipped).
2) Remove the accessory tool (if so equipped).
3) Clean the Long Reach Air Tool with an appropriate
solvent.
OBSERVE ALL APPLICABLE SAFETY
PRECAUTIONS FOR THE SOLVENT.
4) Using the screwdriver, remove the threaded plug,
PN MDF15-0280. The assembly incorporates a right
hand thread configuration.
5) Remove the valve spool, PN MDF15-0300 from the
valve body. Clean the valve spool, spring and valve
housing with an appropriate solvent. Inspect the valve
spool (PN MDF15-0300) and O rings (PN MDF15-0260
and MDF15-0270) for wear, distortion and external
markings. If required, replace the valve and/or the O
rings with a factory approved replacement part only.
FIGURE 26.
OBSERVE ALL APPLICABLE SAFETY
PRECAUTIONS FOR THE SOLVENT.
FIGURE 26
6) Inspect the throttle valve return spring, PN MDF15-
0290, for visible damage, external markings and
proper tension. If necessary, replace with a factory
approved replacement part only.
7) The assembly procedure for the specific
components follows the disassembly procedure in
reverse order. Apply a coating of pneumatic tool
lubrication oil to the valve spool and O rings before
reinstalling the O rings to the spool. This will minimize
the potential for external damage to the O rings. Apply
a small amount of pipe joint compound to the external
threads of the throttle valve cover. Secure tight with the
screwdriver
Storage
Application: All models.
Proper procedure for long term storage of the Long
Reach Air Tool will protect it against the effects of
corrosion and damage. If the Long Reach Air Tool is
not to be operated for a period of 30 days or more,
proceed to store as follows:
1) Disconnect the Long Reach Air Tool from the
compressed air source.
MDF SERIES LONG REACH AIR TOOLS FORM GOM6019801, VERSION 1.0, AUTHORIZATION: DVR, PAGE: 26