En-4
Fig. 6 Remote Control Unit
H
SLEEP button
I
MASTER CONTROL button
J
SET TEMP./SET TIME buttons (
)
K
Signal Transmitter
L
TIMER button
M
FAN CONTROL button
N
START/STOP button
O
AIR FLOW DIRECTION button
P
SWING LOUVER button
Rear side (Fig. 7)
Q
TIME ADJUST button
R
ACL button
(located inside battery compartment)
S
TEST RUN button
●
This button is used when installing the
conditioner, and should not be used un-
der normal conditions, as it will cause the
air conditioner’s thermostat function to op-
erate incorrectly.
●
If this button is pressed during normal op-
eration, the unit will switch to test opera-
tion mode, and the Indoor Unit’s OPERA-
TION Indicator Lamp and TIMER Indicator
Lamp will begin to flash simultaneously.
●
To stop the test operation mode, either
press the TEST RUN button once again, or
press the START/STOP button to stop the
air conditioner.
T
Remote Control Unit Display (Fig. 8)
U
Transmit Indicator
V
Clock Display
W
Operating Mode Display
X
T imer Mode Display
Y
Fan Speed Display
Z
Temperature Set Display
[
T imer Set Indicator
\
Temperature Set Indicator
Fig. 1 Indoor Unit
1
Operating Control Panel (Fig. 2)
2
POWER Switch
3
MANUAL AUTO button
4
Remote Control Signal Receiver
5
Indicator Lamps (Fig. 3)
6
OPERATION Indicator Lamp (red)
●
Lights when unit is operating.
●
The lamp will flash slowly (3 seconds on,
1 second off) when the defrosting opera-
tion (See page 16).
●
The lamp will flash quickly (1 second on, 1
second off) when the selected operating
mode can not be used (See page 18).
7
TIMER Indicator Lamp (green)
●
If the TIMER indicator lamp flashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting
(see page 17 Auto Restart).
8
SWING Indicator Lamp (orange)
9
Intake Grille (Fig. 4)
0
Air Filter
A
Air Flow Direction Louver
B
Right-Left Louvers
(behind Air Flow Direction Louver)
C
Drain Hose
D
Air Cleaning Filter (optional)
Fig. 5 Outdoor Unit
E
Intake Port
F
Outlet Port
G
Pipe Unit