General ASM-HD, Руководство оператора

Страница: 8 / 17

Reassemble the remaining parts to the slicer.
When installing the platform always be sure to tighten the
lock knob. The label at right appears on the machine as a
reminder. (Fig. 20)
ELECTRICAL POWER SUPPLY
The slicer should be placed close enough to the electrical
power supply so that an extension cord will not be
needed. The slicer is designed to be used on 115 Volt,
A.C., 60 Hz power source, as indicated on the Data Plate
which is affixed to the rear of the unit. (Fig. 21)
BE SURE
THAT THE VOLTAGE IS THE SAME BEFORE
PLUGGING SLICER INTO OUTLET.
To operate the unit
on other voltages, the unit must be returned to the factory
ALWAYS USE A PROPERLY GROUNDED THREE-
PRONG OUTLET TO REDUCE THE HAZARD OF
ELECTRICAL SHOCK.
NOTE: It is important that all electrical connections be
made in compliance with all applicable local electrical
codes as well as the latest edition of the National
Electrical Code.
OPERATION
SLICING—MODEL SM-HD OR MANUAL OPERATION OF MODEL
ASM-HD
1. Place platform drive engagement lever in the down (disengaged) position, (Fig. 22)
2. Set platform speed control knob to zero slices per minute. (Fig. 23)
7