General 80-125L, Руководство по установке и эксплуатации

Страница: 15 / 32

A
B
D
C
DEPTH STOP LOCK PIN
SETTING THE IN-FEED TABLE MIN/MAX HEIGHT
In addition to the 1/8” depth stop, 2 other depth stops can
be set by setting the in-feed table minimum and maxi-
mum height.
To set the table minimum height:
1. Loosen bolt A .
2. Adjust in-feed table to the desired minimum height
then re-tighten bolt
A .
To set the table maximum height:
1. Loosen bolt B .
2. Adjust in-feed table to the desired maximum height
then re-tighten bolt
B .
B
A
The depth of cut is set by raising or lowering the in-feed
table.
Refer to the recommended depth of cut settings in sec-
tion “Basic Jointing Operations Instructions”, on page 20.
ADJUSTING AND SETTING THE IN-FEED TABLE HEIGHT / DEPTH OF CUT
WORKPIECE
DEPTH OF CUT
THE MAXIMUM DEPTH OF CUT FOR ONE PASS IS
1/8”. NEVER ATTEMPT TO REMOVE MORE MATERIAL
THAN 1/8” IN ANY SINGLE PASS.
ALWAYS DISCONNECT THE MACHINE FROM THE
POWER SOURCE BEFORE MAKING ANY ADJUST-
MENTS. FAILURE TO HEED THIS WARNING CAN
LEAD TO SERIOUS PERSONAL INJURY.
15
1. Loosen the in-feed table height adjustment hand wheel lock knob A.
2. Pull & hold back the 1/8” depth stop lock-pin B.
Important! Never adjust the table height with the lock-pin engaged as
this will break the pin.
3. Use handwheel C to adjust in-feed table height to the desired depth of cut and then release the 1/8” depth stop
lock-pin B and retighten lock knob A to secure the in-feed table in position and lock the handwheel.
Note: Refer to the graduated depth scale
D
.