General Pump DCFSCP20 The Hammerhead, Руководство оператора

Страница: 2 / 2

ITEM
NO.
PART
NO.
DESCRIPTION QTY.
1 2103065 Swivel, 20” 1
2 2660045 Deck, GP, 20” 1
3 2530009 Arm, Rotary, Assy., 20” 1
4 2630010 Plate, Retaining 1
5 2540023 Collar, Split 1
6 2200055 SHCS, M8 X 1.25 X 30, SST 4
7 2200054 SHCS, M8 x 1.25 x 25, SST 1
8 2540020 Block, Handle 2
9 2200047 Bolt, M6 8
10 2203406 Washer, M6 8
11 2540021 Handle, Lower 1
12 2540037 Handle, Upper 1
ITEM
NO.
PART
NO.
DESCRIPTION QTY.
13 2660047 Grip, Handle 1
14 2660046 Plug, Handle 1
15 2660059 Brush Assy., 20” 1
16 DCG4000FSC Gun, Flat Surface Cleaner 1
17 2702000 Hose, 20” 1
18 2200063 Nut, M8 x 1.25, Nylok, SST 4
19 D10009 Plug, 3/9 x 3/8-M 1
20 D10004 Coupler, 3/8 x 3/8-M 1
21 2200028 Nut, Nylok, M6 2
22 2202010 Pin, 55mm, w/Ring, SST 2
23 2200058 HHCS, M6 X 1 X 60 2
24 2200018 Washer, M6 4
25 2203507 Washer, M6, SST, Lock 1
General Pump
1174 Northland Drive • Mendota Heights, MN 55120
Phone: 651.686.2199 • Fax: 800.535.1745
www.generalpump.com • sales@gpcompanies.com
Ref 300748 Rev.A
08-10
Operating Pressures: 1,000 to 4,000 PSI
Max Flow: 8.0 GPM
Dimensions: 70” x 21” x 21”
Weight: 21 lbs.
Operating Instructions
1. Connect to Pressure Washer.
2. Turn water on and open valve. Open trigger gun for flow of water
through nozzles. Nozzles must have flowing spray. If not, remove
tips and clean; reassemble, making sure that groove of nozzle is
parallel to spray bar. Use thread sealant when installing nozzles.
3. Start Pressure Washer. The Hammerhead is ready for operation.
4. Walk slowly behind the Hammerhead cleaning as you go. If
striping occurs, slow down your pace.
5. Periodically check weep hole on bottom of swivel. Water will
seep slowly; if water shoots out, stop and replace seals. Swivel
assembly can be rebuilt.
6. For maximum effectiveness keep spray tips clean. If the machine
vibrates, stop and clean spray tips.
7. Lubricate swivel with one squirt of good quality grease every 200
hours of operation or about once a month if used daily. A small
amount of grease coming out of the swivel is normal.
DO NOT ALLOW MACHINE TO REMAIN STATIONARY
ON SOFT SURFACES SUCH AS WOOD.
Caution: Striking any raised obstacle during operation will damage
machine. If contact does occur and results in vibration when
operating machine, STOP and replace spray bar. Continued
operation could result in serious injury or damage to machine.