3.
Turn the stand and table assembly upright and tight-
en all bolts.
Note: If you previously threaded all the fasteners into the
underside of the cast-iron table, the leveler screws will
already be in place. If you didn’t, thread them in now. The
nut will sit on the top side of the flange that the router
lift/plate will rest on.
CAST-IRON TABLE #40-100C AND PHENOLIC TABLE #40-100P ONLY)*
Note: You will find 6 additional side bracket mounting fasteners in the fence hardware to attach the side brackets to the
cast iron table. These will not be required if you have purchased a complete kit, because the same fasteners have been
supplied with the table top.
For #40-047 MDF table (for #40-100M), use the wood screws supplied with your table to attach the mounting brackets
to the table.
*
2.
Remove the original 6 fence bracket mounting bolts
A
from the table and attach one fence mounting
brackets to the underside of the table,
B
, using 3 bolts.
A
B
D
1.
Attach the two fence side rails with scale
A
to their
mounting brackets
B
, using 3 hex head bolts with flat
washers and square nuts
C
, in the assembly order
shown in
D
.
A
C
B
14
40-065 ROUTER FENCE
Note: The hex head bolts and square nuts supplied with the fence are coarse thread and the hex head bolts supplied to attach
the #40-130 Dust Enclosure are fine thread.
1.
With the table upside down, remove the 4 mounting
screws and washers,
A
, for the stand.
ATTACH THE TABLE TO THE STAND (CAST-IRON TABLE #40-100C AND PHENOLIC TABLE #40-100P ONLY)*
* For #40-047 MDF table (for #40-100M), use the wood screws supplied with your table to attach the stand to the table.
A
2.
Attach the stand to the table using the four socket
head cap screws and washers,
B
, then tighten.
B
Before opening the fence, have a clear work area to prevent the mixing of hardware.
