General International 50-eb3, Руководство по установке и эксплуатации

Страница: 5 / 10

ASSEMBLY
1) Remove the unit from the box and unfold it.
4) Assemble and attach the flip stop as per flip stop exploded views below.
NOTE: If you choose to use the self adhesive abrasive on the fence:
separate the fence from the rest of the assembly. Remove the paper
backing and apply to the smooth face of the fence. Apply pressure
over the entire surface with the palm of your hand or with a hard rub-
ber roller. Trim the excess by running a utility knife against the edge
of the fence all the way around the outside.
To apply the measure tape, remove the backing to expose the adhe-
sive film, then stick the measuring tape to the top of the fence.
The glide tape can be applied by sticking it to the bottom of the glide
bar.
For use on the left side of the
table saw.
When you assemble the stop,
tighten the top lock nut until
the slide and the stop are
tight. Back off the nut slightly
allowing the stop to pivot on
the bolt.
For use on the right side
of the table saw.
After your stop is
assembled in the desired
orientation, slide the
head of bolt into the
track slot that runs along
the top of the fence.
2) Slide the inner brace into the red outer
brace then tighten the angle clamp knob. 3) Attach the handle to the guide bar.
Inner
Brace
Outer
Brace
Angle Clamp
Knob
Handle
Guide
Bar
5
Applying measure tape.
Applying glide tape.
Apply abrasive to fence.
Flip fence over, trim abrasive
to size.
Applying the abrasive