General Hobby Piper J3, Инструкция по сборке

Страница: 10 / 22

Rudder Installation
Find out the slot pre-opened for rudder control horn, remove the film
Fit the control horn into the slot, measure the correct length for it
Cut the longer part. Glue the horns into the rudder of each side
Repeat the same method on the other side of the rudder.
Thread the cable connecter halfway into the ball link .
Connect the pull-pull wire and control horn with ball link
Drill holes for the mounting screws. Fit the servos as shown with the servo
label facing the rudder. Harden the area around the holes with a
drop of thin CA.
Use brass crimps on each cable and thread, the cable through the end of the
pullpull connector.
Crimp the brass tube with a crimping tool or pliers
A drop of thin CA may be applied to the brass tube to help secure the cable
Install the rudder ball links with bolts and locking nuts.
Check the pull-pull cables.
Rudder and the rudder servo should both be in the neutral position.