Switch Fabric and V6.2 Controllers
Switch Fabric Setup
032R440-000
Xedge 6000 Hardware
3-9
Issue 17
Installation & Setup Guide
XH/XS Switch Fabric Hardware Setup
The Xedge XH Switch Fabric module is intended for use in the Xedge 6640 and Xedge 6645
chassis. The XS Switch Fabric module intended for the Xedge 6280 chassis. Onboard jumpers
control XH/XS traffic priority and modes of operation: XH mode (50 MHz), or XP mode (25 MHz).
The jumpers on the XH/XS Switch Fabric must be configured or checked before installing the
module in the chassis.
show the location and describe the function of pin
pairs on each jumper. Hold the board as shown with the component side facing you and the front
panel to the left. In this position, references to “upper” or “lower” in the table are the “upper” or
“lower” jumper positions.
Figure 3-4
XH/XS Jumper Locations
FRONT PANEL
Jumper in upper position.
Jumper in lower position.
LEGEND
JP3
XH/XS CIRCUIT BOARD
JP1
JP4
JP2