Generac Power Systems RTSF100A1, Руководство по установке

Страница: 3 / 20

1
INTRODUCTION
Thank you for purchasing this 100 Amp Automatic Transfer
Switch/Load Center with Express Install Kit. The Express
Install Kit includes:
• 30 foot, five foot, and two foot pre-wired conduits for
making all required wiring runs.
• An outdoor junction box for making connections between
outdoor and indoor pre-wired conduits.
• UL listed wire nuts for reconnecting emergency circuits
within the main distribution panel.
The 100 Amp Automatic Transfer Switch/Load Center with
Express Install Kit can be installed along with a 8, 10, 12,
14, 16 or 17kW Air-cooled Standby Generator, or can be
used to pre-wire a home or small business in advance of
generator installation. In either case, the Express Install Kit
saves installation time and cost, since the majority of labor
involved in installing a standby power system is in wiring the
generator, automatic transfer switch and emergency circuit
subpanel.
Four commonly used safety symbols accompany the
DANGER, WARNING and CAUTION blocks. The type of
information each indicates follows:
DANGER
After this heading, read instructions that, if not strictly
complied with, will result in serious personal injury,
including death, and/or severe property damage.
After this heading, read instructions that, if not strictly
complied with, may result in serious personal injury
and/or property damage.
After this heading, read instructions that, if not strictly
complied with, could result in damage to equipment
and/or property.
NOTE:
After this heading, read explanatory statements that
require special emphasis.

This symbol points out important safety information
that, if not followed, could endanger personal safety
and/or property.

This symbol points out potential explosion hazard.

This symbol points out potential fire hazard.

This symbol points out potential electrical shock
hazard.

SAVE THESE INSTRUCTIONS – The manufacturer
suggests that these rules for safe operation be
copied and posted near the unit’s installation site.
Safety should be stressed to all operators and
potential operators of this equipment.
The manufacturer cannot anticipate every possible circum-
stance that might involve a hazard. The warnings in this
manual, and on tags and decals affixed to the unit are there-
fore, not all-inclusive. If using a procedure, work method or
operating technique the manufacturer does not specifically
recommend, ensure that it is safe for all personnel. Also
make sure the procedure, work method or operating tech-
nique chosen does not render the equipment unsafe.

ELECTRICAL HAZARDS

• Utility power delivers extremely high and dangerous volt-
ages to the transfer switch as does the standby generator
when it is in operation.
• Do not handle any kind of electrical device while standing
in water, while barefoot, or while hands or feet are wet.
DANGEROUS ELECTRICAL SHOCK MAY RESULT.
• In case of accident caused by electric shock, immediately
shut down the source of electrical power. If this is not
possible, attempt to free the victim from the live conduc-
tor. AVOID DIRECT CONTACT WITH THE VICTIM. Use
a non-conducting implement, such as a rope or board,
to free the victim from the live conductor. If the victim is
unconscious, apply first aid and get immediate medical
help.
• Never wear jewelry when working on this equipment.
Jewelry can conduct electricity resulting in electric
shock, or may get caught in moving components causing
injury.
Residential Transfer Switch Installation Guide
PLEASE NOTE:
This installation guide should be used in conjunction with the “Installation and Owner’s Manual” that is fur-
nished with the Air-cooled Standby Generator. Please review both manuals prior to installation of the
generator and transfer switch. This Automatic Transfer Switch/Load Center is not intended for use with the
Liquid-cooled Generator product line. This unit is not compatible with other generator manufacturer’s products.