Generac Power Systems Power Washer, Руководство оператора

Страница: 6 / 58

4 Operator’s Manual for Power Washer
Emissions Information
The U.S. Environmental Protection Agency
(and California Air Resource Board for equip-
ment certified to CA standards) requires that
this engine comply with exhaust and evapora-
tive emission standards. Locate the emissions
compliance decal on the engine to determine
what standards the engine meets, and to
determine which emissions warranty applies.
The engine is certified to meet the applicable
emission standards on gasoline. It is important
to follow the maintenance specifications in the
Maintenance section to verify that the engine
complies with the applicable emission stan-
dards for the duration of the product’s life. This
engine utilizes lean carburetion settings and
other systems to reduce emissions. Tamper-
ing with or altering the emission control sys-
tem may increase emissions and may be a
violation of Federal or California Law. Acts that
constitute tampering include but are not lim-
ited to:
• Removal or alteration of any part of
the intake, fuel, or exhaust systems.
• Altering or defeating the governor link-
age or speed-adjusting mechanism to
cause the engine to operate outside
its design parameters.
Have the engine inspected and repaired by a
servicing dealer if these symptoms develop:
• Hard starting or stalling after starting
• Rough idle
• Misfiring or backfiring under load
• Afterburning (backfiring)
• Black exhaust smoke or high fuel con-
sumption
NOTE : Maintenance, replacement, or repair of
emissions control devices and systems may
be performed by small engine repair establish-
ment or individual. To be covered by warranty,
all emissions control service work must be
performed by a factory authorized dealer. See
emissions warranty for further details.
Remove Contents from Carton
1. Open carton completely by cutting
each corner from top to bottom.
2. Remove and verify carton contents
prior to assembly. Carton contents
should contain one each of the follow-
ing:
• Main Unit
• Handle Assembly
• High-pressure Hose
• Siphon Hose & Filter
• Spray Gun
• Lance with Quick Connect Fitting
• Oil Bottle
• Hose Hook
• Parts Bag (includes):
– Chemical/Detergent Tank Cap (if
equipped)
– Owner’s Manual
– Owner’s Registration Card
– Bag of Colored Nozzles
3. Call Generac Customer Service 1-
888-436-3722 with the unit model and
serial number for any missing carton
contents.
4. Record model, serial number, and
date of purchase on front cover of this
manual.
Assembly
Call Generac Customer Service at 1-888-436-
3722 for any assembly issues or concerns.
Please have model and serial number avail-
able.
1.
See Figure 2-2. Insert handle and lock
into place
Figure 2-2. Insert Handle
2. See Figure 2-3. Squeeze and Install
hose hook.
Figure 2-3.Install Hose Hook
3. See Figure 2-4. Insert and snap nozzles
into spaces provided in handle.
B
:$51,1*
$POTVMU.BOVBM3FBEBOEVOEFSTUBOENBOVBM
DPNQMFUFMZCFGPSFVTJOHQSPEVDU'BJMVSFUP
DPNQMFUFMZVOEFSTUBOENBOVBMBOEQSPEVDU
DPVMESFTVMUJOEFBUIPSTFSJPVTJOKVSZ