Generac Power Systems Magnum MGG100M, Руководство оператора

Страница: 63 / 84

Maintenance
36833 C MGG100M Operating Manual 55
1. Connect red battery cable of starter contactor to the positive (+) battery post.
2. Connect the black battery cable from the battery disconnect to the negative (-) battery post.
Final instructions:
1. Turn battery disconnect switch to ON.
2. Verify controller is powered—display screen lights up.
CAUTION
Damage will result if the battery connections are made in reverse.
OTHER MAINTENANCE CHECKS
The maintenance items below require a high level of experience and skill to evaluate and correct.
• Inspect engine accessory drive belts
• Inspect hoses and connections
• Inspect fuel supply system
• Inspect exhaust system
• Inspect exhaust blankets. Replace if deteriorated.
Note: When disconnecting or replacing the catalyst or exhaust pipes, 1) the clamps and exhaust blankets MUST be
replaced, and 2) there can be no leaks in the exhaust system.
Ignition and Distributor Timing
All distributor servicing MUST be performed by a GMPASD. Removal of the tamper-resistant cap by anyone other
than a GMPASD constitutes a violation of Federal law and is subject to civil penalties.
• Every 250 hours, verify the ignition timing is 18° BTDC. If timing is not 18° BTDC, have a GMPASD correct it.
• Every 2000 hours, have a GMPASD replace the distributor and reset timing to 18° BTDC.
Integrated Electronic Pressure Regulator (IEPR)
If the IEPR fails to operate or develops a leak, it should be repaired or replaced with the OEM recommended
replacement parts. When inspecting the system, check for the following items:
• Check for any fuel leaks at the inlet and outlet fittings.
• Check for any fuel leaks in the IEPR body.
• Check the inlet and outlet fittings of the coolant supply lines for water leaks, if applicable.
• Ensure the IEPR is securely mounted and the mounting bolts are tight.
• Check the IEPR for external damage.
• Check the IEPR electrical connection to ensure the connector is seated and locked.