Generac Power Systems MAC1.2G, Руководство пользователя

Страница: 25 / 36

Owner’s Manual for Indirect Fired Heater 21
Maintenance
1. Connect battery cable from starter contactor to
positive (POS or +) battery post.
2. Connect black battery cable to negative (NEG or -)
battery post.
3. Refer to Engine and Heater Startup .
Other Maintenance Checks
The following inspections should be performed by an
authorized service technician, or a properly trained auth-
orized operator. These maintenance items require a high
level of experience and skill to evaluate and correct.
• Inspect engine accessory drive belts.
• Inspect hoses and connections.
• Inspect fuel supply system.
• Inspect exhaust system.
• Inspect exhaust pipe sleeve.
Trailer Maintenance
Perform daily inspections of the trailer before each use.
• Inspect trailer for damage, such as dents, cracks,
gouges, or deep scratches.
• Inspect trailer for corrosion or abrasion.
• Inspect trailer tires for wear and deflation.
• Inspect all safety devices for damage or unusual
wear.
• Inspect all electrical connections for any bare wires
or other damage.
• Rectify any issues before using the trailer.
Short Term Storage
When the machine will not be in use for three or more
months, follow the guidelines below to properly store the
machine:
• Perform all necessary maintenance or repairs
based on the
Maintenance Schedule . Perform
any upcoming necessary maintenance task before
storing.
• Fill the fuel tank to FULL.
• Fill coolant to FULL. Do not drain.
• Remove all dirt and debris from inside and outside
the enclosure.
• Lock the machine to prevent any unauthorized
operation.
• Store in a safe location — do not position near or
on top of any combustible materials; observe any
local, state, or national codes or regulations. Store
in a low moisture, low dust area.
• Disconnect the negative cable from the battery.
Return to Service
Follow the guidelines below for engines and machines
that have not been operated for three to six months:
• Conduct a thorough inspection of the machine
before starting the engine.
• Verify the maintenance schedule is up to date.
• Connect the negative battery cable.
• After starting the engine, let it warm up for more
than 10 minutes at idle.