Generac Power Systems 04635-0 Скачать руководство пользователя страница 16

Part No. 0D4001

Revision C (10/17/03)

Printed in U.S.A.

Section 7 — Warranty

Generac GTS “W” Type Transfer Switch

GENERAC POWER SYSTEMS STANDARD TWO-YEAR LIMITED WARRANTY

FOR GENERAC TRANSFER SWITCH SYSTEMS

For a period of 2 (two) years from the date of sale, Generac Power Systems, Inc. will, at its option, repair or replace any
part(s) which, upon examination, inspection, and testing by Generac Power Systems or a Generac Power Systems
Authorized Warranty Service Dealer, is found to be defective under normal use and service, in accordance with the
warranty schedule set forth below. Any equipment that the purchaser/owner claims to be defective must be examined by
the nearest Generac Power Systems Authorized Warranty Service Dealer. All transportation costs under the warranty,
including return to the factory, are to be borne and prepaid by the purchaser/owner. This warranty applies only to
Generac Power Systems Transfer Switch applications, as Generac Power Systems, Inc. have defined Transfer Switch
application. 

WARRANTY SCHEDULE

YEAR ONE

— 100% (one hundred percent) coverage labor, and parts listed.

ALL COMPONENTS

YEAR TWO

— 100% (one hundred percent) coverage on parts listed.

ALL COMPONENTS — *PARTS ONLY

• A Generac Power Systems, Inc. Transfer Switch is highly recommended to be used in conjunction with the genset. If a

non Generac genset is substituted for use and directly causes damage to the Generac Transfer Switch, no warranty 
coverage shall apply.

• All warranty expense allowances 

are

subject to the conditions defined in Generac Power Systems Warranty, Policies, and

Procedures Flat Rate Manual.

• Units that have been resold 

are not

covered under the Generac Power Systems Warranty, as this Warranty 

is not

transferable.

THIS WARRANTY SHALL NOT APPLY TO THE FOLLOWING:

1. Any unit built/manufactured prior to January 1, 2002.
2. Unit enclosure is only covered against rust or corrosion the first year of the warranty provision.
3. Costs of normal maintenance i.e. tune-ups, associated part(s), adjustments, loose/leaking clamps, installation and start-up.
4. Use of Non-Generac replacement part(s) will void the warranty in its entirety.
5. Damage related to rodent or insect infestation
6. Failures due, but not limited to, normal wear and tear, accident, misuse, abuse, negligence, or improper installation or

sizing.

7. Failures caused by any external cause or act of God such as collision, fire, theft, freezing, vandalism, riot or wars, lightning,

earthquake, windstorm, hail, volcanic eruption, water or flood, tornado, hurricane, terrorist acts or nuclear holocaust.

8. Products that are modified or altered in a manner not authorized by Generac Power Systems in writing.
9. Any incidental, consequential or indirect damages caused by defects in materials or workmanship, or any delay in

repair or replacement of the defective part(s).

10. Failure due to misapplication, or misrepresentation.
11. Telephone, cellular phone, facsimile, internet access or other communication expenses.
12. Living or travel expenses of person(s) performing service, except as specifically included within the terms of a specific

unit warranty period.

13. Rental equipment used while warranty repairs are being performed.
14. Overtime labor.
15. Expenses related to “customer instruction” or troubleshooting where no manufacturing defect is found.
16. Overnight freight costs for replacement part(s).

THIS WARRANTY IS IN PLACE OF ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED, SPECIFICALLY, GENERAC

POWER SYSTEMS MAKES NO OTHER WARRANTIES AS TO THE MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE. Some states do not allow limitations on how long an implied warranty lasts, so the above
limitation may not apply to you.

GENERAC POWER SYSTEMS ONLY LIABILITY SHALL BE THE REPAIR OR REPLACEMENT OF PART(S) AS STATED

ABOVE. IN NO EVENT SHALL GENERAC POWER SYSTEMS BE LIABLE FOR ANY INCIDENTAL, OR CONSEQUENTIAL
DAMAGES, EVEN IF SUCH DAMAGES ARE A DIRECT RESULT OF GENERAC POWER SYSTEMS, INC. NEGLIGENCE.

Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations may

not apply to you. Purchaser/owner agrees to make no claims against Generac Power Systems, Inc. based on negligence.

This warranty gives you specific legal rights. You also may have other rights that vary from state to state.

GENERAC

®

POWER SYSTEMS, INC. 

P.O. BOX 297

WHITEWATER, WI 5319087

Содержание 04635-0

















Отзывы: