Generac Portable Products 1417-1, Руководство пользователя

Страница: 8 / 24

Generac Portable Products 2,500 PSI High Pressure Washer
8 8
HOW TO USE YOUR
PRESSURE WASHER
If you have any problems operating your pressure washer,
please call the pressure washer helpline at
1-800-270-1408.
How to Start Your Engine
The best way to start your engine–powered pressure
washer for the first time is to follow these instructions
step–by–step. This starting information also applies
whenever you start the engine after you have let the
pressure washer sit idle for at least a day.
• Place the pressure washer in an area close enough to an
outside water source that can flow at a rate of
3.3 gallons per minute or more.
• Make sure the unit is in a level position.
• Check that the high pressure hose is tightly connected to
the spray gun and to the pump. See “Preparing Pressure
Washer for Use” on page 5.
• Connect the garden hose to the water inlet on the
pressure washer pump and turn on the water.
WARNING!
Do Not run the pump without the
water supply connected and turned on. You must
follow this caution or the pump will be damaged.
• Squeeze the trigger on the spray gun (make sure the
nozzle is in low pressure mode) to relieve the air
pressure caused by turning ON the water. Water will
discharge from the gun in a thin stream. Hold the trigger
until a steady stream of water appears. This will make it
easier to pull start the engine. Release the trigger.
• Apply the safety latch to the spray gun trigger.
• Move the fuel valve to the “On” position (Figure 7).
• Move the throttle lever to the “Fast” position (Figure 8).
• To start a cold engine, move the choke lever to the
“Closed” position. To restart a warm engine, leave
the choke lever in the “Open” position (Figure 9).
Figure 7 — Fuel Valve
On
Off
Figure 8 — Throttle Positions
Throttle Lever
Fast
Slow
Figure 9 — Choke Positions
Choke Lever
Closed
Open