Generac Portable Products 1417-1, Руководство пользователя

Страница: 11 / 24

Generac Portable Products 2,500 PSI High Pressure Washer
11 11
SPECIFICATIONS
Outlet Pressure . . . . 2,500 PSI
Flow Rate . . . . . . . . . . 3.0 gallons per minute (gpm)
Detergent . . . . . . . . . Use detergent approved for
pressure washers
Water Supply . . . . . . Not to exceed 140°F
Temperature
Automatic Cool . . . . Will cycle when water
Down System
reaches 140°-145°F
GENERAL MAINTENANCE
RECOMMENDATIONS
The high pressure washer warranty does not cover items
that have been subjected to operator abuse or negligence.
To receive full value from the warranty, the operator must
maintain the high pressure washer as instructed in this
manual.
• Some adjustments will need to be made periodically to
properly maintain your high pressure washer.
• All adjustments in the Maintenance section of this manual
should be made at least once each season.
• Once a year you should clean or replace the spark plug
and clean or replace the air filter and check the gun and
nozzle extension assembly for wear. A new spark plug
and clean air filter assure proper fuel–air mixture and
help your engine run better and last longer.
Before Each Use
• Check engine oil level.
• Check water inlet screen for damage.
• Check high pressure hose for leaks.
• Check chemical injection tube and filter for damage.
• Check gun and nozzle extension assembly for leaks.
• Rinse out garden hose to flush out debris.
PRESSURE WASHER
MAINTENANCE
Check and Clean Inlet Screen
Examine the screen on the water inlet. Clean it if the
screen is clogged or replace it if screen is damaged.
Check High Pressure Hose
The high pressure hose can develop leaks from wear,
kinking, or abuse. Inspect the hose each time before using
it. Check for cuts, leaks, abrasions or bulging of cover,
damage or movement of couplings. If any of these
conditions exist, replace the hose immediately.
DANGER!
Water spraying from a leak is capable
of injecting material into skin. Inspect hose each
time before using it. Never repair a high pressure
hose. Replace it with another hose that exceeds the
maximum pressure rating of your pressure washer.
Check Gun and Nozzle Extension
Examine the hose connection to the gun and make sure it
is secure. Test the trigger by pressing it and making sure it
springs back into place when you release it. Put the safety
latch in the on position and test the trigger. You should not
be able to press the trigger.
Check In-Line Filter
Refer to Figure 13 and service the in-line filter if it
becomes clogged, as follows:
1. Detach gun and nozzle extension from high pressure
hose. Detach nozzle extension from gun and remove
o-ring and screen from nozzle extension. Flush the
screen, gun, and nozzle extension with clean water to
clear debris.
Figure 13 — Service In-Line Filter
Nozzle Extension
O-Ring
Filter Screen