Generac Portable Products 1295-0, Руководство пользователя

Страница: 15 / 24

15
Generac Portable Products 3200PSI High Pressure Washer
Nozzle Maintenance
If the nozzles becomes restricted or clogged with
foreign materials, such as dirt, excessive pump
pressure may develop. If the nozzles become partially
clogged, it can cause a pulsing sensation during use.
This generally is not a pump related problem, but
rather a clogged or partially restricted nozzle.
If the nozzles become clogged or partially restricted,
immediately clean the nozzles with the kit included
with your pressure washer by following these
instructions:
• Shut off the engine and turn off the water supply.
• Remove the nozzle from the end of the nozzle
extension.
• Use the wire included in the kit or a small paper clip
to free the foreign materials clogging or restricting
the nozzle (Figure 16).
• Remove additional debris by rinsing out the nozzle.
Rinse between 30 to 60 seconds.
• Reinstall the nozzle into the nozzle extension.
• Reconnect the water supply, turn on the water, and
start the engine.
• Test the pressure washer.
ENGINE MAINTENANCE
See the Engine Owner’s Manual for instructions on
how to properly maintain the engine.
ENGINE SERVICE
See the engine Owner’s Manual for instructions on
how to properly service and adjust the engine.
PREPARING UNIT FOR
STORAGE
Water should not remain in the unit for long periods of
time. Sediments of minerals can deposit on pump
parts and “freeze” pump action. If you do not plan to
use the pressure washer for more than 30 days,
follow this procedure:
1. Flush chemical injection tube by placing the filter
into a pail of clean water while running pressure
washer with the black chemical nozzle. Flush for
one to two minutes.
2. Shut off the engine and let it cool, then remove all
hoses.
3. Place the throttle lever in STOP position.
WARNING!
Be sure lever is in “STOP”
position before you continue. If you start
engine without proper water supply connected,
you can damage pump.
4. Empty the pump of all pumped liquids by pulling
the recoil handle about 6 times. This should
remove most of the liquid in the pump.
NOTE: To protect the unit from freezing temperatures,
draw RV antifreeze (no alcohol) into the pump by
pouring the antifreeze into a 3–foot section of garden
hose connected to inlet adapter and pulling recoil
handle twice.
5. Store in a clean, dry area.
STORING THE ENGINE
See the Engine Owner’s Manual for instructions on
how to properly store the engine.
Figure 16 — Nozzle Maintenance
Use wire here
to remove
debris.