Generac 2250PSI High Pressure Washer
GENER
A
C
The Reliable Ones
7
A
SSEMBL
Y
Insert the carriage bolts through the holes on the
handle and attach the plastic knobs. Tighten the
knobs by hand (Figure 2).
Insert the wire support with the longer arm positioned
on the left. From this view (from rear of unit) the hook
should resemble a J. (Figure 3)
Add Engine Oil
IMPORTANT:
Any attempt to start the engine before
it has been properly serviced with the recommended
oil may result in an engine failure.
Note:
When adding oil to the engine crankcase, use
only high quality detergent oil rated with API service
classification SF,SG, SH or rated SAE 30 weight.
Select the oils viscosity grade according to your
expected operating temperature. Do Not Use SAE
10W40 Oil.
Although multi-viscosity oils (5W30, 10W30, etc.)
improve starting in cold weather, these multi-viscosity
oils will result in increased oil consumption when used
above 32°F. Check your engine oil level more
frequently to avoid possible damage from running low
on oil.
Place pressure washer on a level surface.
Clean area around oil fill and remove yellow oil fill
cap (Figure 4)
Wipe dipstick clean. Pour oil into oil fill opening until
oil reaches FULL mark on the dipstick. Stop
occasionally to check oil level. DO NOT OVERFILL.
Install oil dipstick, hand tighten securely.
Note: Check oil often during engine breakin.
Add Gasoline
DANGER! Never fill fuel tank indoors.
Never fill fuel tank when engine is
running or hot. Do not smoke when filling
fuel tank.
WARNING! Never fill fuel tank completely
full. Fill tank to about 1/2" below the
bottom of the filler neck to provide space
for fuel expansion. Wipe away any fuel
spillage from engine and equipment
before starting.
DANGER! DO NOT operate or refuel
engine with spark plug access hole
cover removed. Allow engine to cool 2
minutes before refueling.
Figure 3 — Fit wire form on handle.
Figure 4 — Add oil to engine crankcase. Do not
attempt to start engine without
adding oil.
Oil Fill Cap
Figure 2 — Insert the carriage bolts and attach
the plastic knobs.
colder
32°F
warmer
5W30
SAE 30
