1034BC SYSTEM
SPECIFICATIONS
AMPLIFIER
SECTION
CROSSOVER
SECTION
Lower cut-off frequency, -3 dB:
< 32 Hz
Upper cut-off frequency, -3 dB:
> 20 kHz
Free field frequency response of system:
33 Hz - 20 kHz (± 2.5 dB)
Maximum short term sine wave acoustic output
on axis in half space, averaged from 100 Hz to
3 kHz:
@ 1m > 123 dB SPL
Maximum long term RMS acoustic output in
same conditions with IEC-weighted noise
(limited by driver unit protection circuit):
@ 1m > 118 dB SPL
Maximum peak acoustic output per pair @ 2m
from the engineer with music material:
> 125 dB
Self generated noise level in free field @ 2m on
axis:
< 15 dB(A)
Harmonic distortion at 100 dB SPL @ 1m on
axis:
Freq: 50...200 Hz <1%
200...10k Hz <0.5%
Drivers:
Bass: 2 x 305 mm (12") cone
Mid:130 mm (5") cone
Treble: 25 mm (1") metal
dome
All drivers are magnetically shielded
Speaker weight: 84 kg (185 lb)
Speaker dimensions (horizontal mounting):
Height 489 mm
(19
1
/
4
")
Width
1210 mm
(47
5
/
8
")
Depth
412 mm
(16
1
/
8
") *
Bass amplifier output power with an 8 Ohm
load:
Short term
2 x 400 W
Mid amplifier output power with an 8
Ohm
load:
Short term
350 W
Treble amplifier output power with an 8
Ohm load:
Short term
120 W
Long term output power is limited by driver
unit protection circuitry.
Slew rate:
80 V/µs
Amplifier system distortion at nominal output:
THD
<0.05%
SMPTE-IM
<0.05%
CCIF-IM
<0.05%
DIM 100
<0.05%
Signal to Noise ratio, referred to full output:
Bass
>100 dB
Mid
>100 dB
Treble
>100 dB
Mains voltage: 100/200 or 115/230V
Voltage operating range at
230V setting:
207 - 244 V (-10/+6 %)
115V setting:
104 - 122 V (-10/+6 %)
Power consumption:
Idle
70 W
Full output
1000 W
Amplifier weight:
30 kg (66 lb)
Amplifier dimensions:
Height
310 mm
(12
3
/
16
")
Width
483 mm
(19")
Depth
250 mm
(9
13
/
16
")*
Input connector: XLR female
pin 1
gnd
pin 2
+
pin 3
-
Input impedance: 10 kOhm balanced
Input level for 100 dB SPL output @ 1m:
variable from +6 to -6 dBu
Input level for maximum short term output of 126
dB SPL @ 1m:
variable from +32 to +20 dBu
Subsonic filter below 27 Hz :
18 dB/octave
Ultrasonic filter above 22 kHz:
12 dB/octave
Crossover frequencies:
Bass/Mid
400 Hz
Mid/Treble
3.2 kHz
Crossover acoustical slopes:
>24 dB/octave
Level control operating range in 1 dB steps:
Bass
from 0 to -6 dB & MUTE
Mid
from 0 to -6 dB & MUTE
Treble
from 0 to -6 dB & MUTE
Bass roll-off control in 2 dB steps:
from 0 to -8 dB @ 32 Hz
Bass tilt control operating range in 2 dB steps:
from 0 to -8 dB @ 50 Hz
The 'CAL' position is with all tone controls set to
'off' and input sensitivity control to maximum.
Genelec Oy, Olvitie 5
FIN - 74100 IISALMI, FINLAND
Phone: +358 - 17 - 83 881
T358 - 17 - 812 267
Email:
Web:
www.genelec.com
Genelec document DR34BC001
COPYRIGHT GENELEC OY 1999
All data subject to change without prior notice
* Without connecting cable. Cable connectors require additional 100 mm (4") of space behind the speaker and the amplifier
Genelec Inc., 7 Tech Circle
NATICK, MA 01760, U.S.A.
Phone: +1 508 652 0900
Fax: +1 508 652 0909
Email: [email protected]
