background image

Step 1A - Remove skins

Step 1B - Remove gas tank & drain lines

=

+

+

    1a-1 Remove choke label
(Propane does not use choke).

1a-3 Remove gas cap by
removing cotter snap pin.

1a-4/5 Unscrew and tilt out front bezel (4 screws).

1a-6 Remove rear bezel (4 screws).

1a-7/8 Remove two handle screws.

1a-10/11 Remove lower skins 
bolts (2 10mm bolts).

1a-12 Remove screw near pull handle.

1a-13 Gently remove skins.

1b-1 Remove fuel line clamp at
bottom of gasoline tank 

 AFTER

FULLY DRAINING GASOLINE!

1b-2 Remove fuel tank by separating 
plastic frame at very top and gently lifting 
up on tank.

1b-3/4 Remove fuel drain & vent tubes (3 tubes).

1b-5 Remove 2 fuel tank bottom bumpers.

Before Starting: DRAIN OUT ALL GASOLINE FROM TANK AND FLOAT BOWL AND DISPOSE OF SAFELY

Genconnex

®

Genconnex

® 

Honda EU2200i 

Propane kit 

Assembly Instructions

Version 2.03

1a-9 Remove lower trim (this 
side only) by prying off with finger 
or flat blade screw driver.

Step 1C - Remove air cleaner box

Step 1D - Remove choke

Step 1G - Remove carburetor & bolts & ground screw

Step 1F - Remove gasoline lines & pump

1c-1/2/3/4/5/6 Remove air cleaner unit by first removing outer cover then one inner 8mm hex bolt, vent tube, then two outer 8mm hex nuts then slide off air cleaner assembly.

1d-1/2/3 Remove pressed-in choke plate by pulling outward with pliers (use force), 
then turn handle full right then pulling up. 

1f-1/2/3/4/5 Remove gas pump & line to carburetor, engine vent below carburetor, then remove gas lines from plastic holders (leave bracket in place for new fuel line) 
and then remove two screws holding pump to frame.  Then remove fuel feed tube below pump going two switch.  This should free up pump for removal.

1g-1/2/3/4 Remove two 8mm long bolts (to be replaced later with longer bolts) holding carburetor to engine by removing two shorter 8mm flange bolts. 
Remove ground screw and save..

1h-1 Remove ground screw and keep for later attaching ground additional strap for Propane Module.

Step 1

Dis-assembly

Engineered to the next level.

Genconnex

®

35 Pond Park Road, Hingham, MA 02043 

1-800-341-0792

#1 Phillips dead screw driver
#2 Phillips head screw driver
flat head screw driver
8mm socket
10mm socket
3/8” socket
pliers or channel locks
microwave oven or boiling water
5/32” Allen head socket or wrench

Copyright 2020 New England Gen-Connect LLC. All rights reserved.

1a-2 Remove access door.

https://genconnexdirect.net/liturature.htm

On-Line PDF

Отзывы: