RXC-3000
Hardware Installation and User Guide
9000-0000-040 Revision 10
10 of 46
Genave Electronics
How the Outputs work
The RXC-3000 comes equipped with 5 Single Pole Single Throw (SPST) high power relays. Additionally, the
RXC-3000 has an output header where the installer can tap into the transistors that control the relays as well as
3 additional transistors that are open for special use. During the running of a script, a command in the script will
tell an output to turn on and/or off. Scripts can have timers embedded in them which allow relays to cycle on and
off continuously for a predetermined amount of time (e.g. wail signal for 3 minutes).
How the Audio Port works
The RXC-3000 can control an external amplifier. Not only does it send audio out this port, but it has control
points in the port to power up and enable several different types of amplifiers. Two pins in the port are connected
to the 600 ohm transformer which allows audio from the ADPCM or radio to be sent to the amplifiers.
How the 600 Ohm port works
The RXC-3000 can send radio or ADPCM audio through a balanced 600 Ohm audio transformer for use by
installers when they need to interface the RXC-3000 to an external PA system.
Building Blocks
