LRAD-100X
GENASYS INC.
Manual Part No.: 106457-00 Rev E
4
3.1 Charging the Battery
Prior to powering up the LRAD-100X, the battery must be fully charged. To charge the system
battery, perform the following steps:
1.
Connect the battery’s male-end circular cable connector to its female counterpart on
the AC battery charger.
2.
Plug the charger into an AC wall outlet. The charger can draw power from wall outlet
voltages rated between 100 and 240 VAC.
3.
Allow the battery to charge until the indicator LED on the charger shows that charging is
complete. The LED will glow red when the battery is charging and will turn green when
the battery is fully charged.
3.2 Installing the Battery
Figure 2 – LRAD-100X Battery Compartment
1.
Disconnect the battery from its charger.
2.
Loosen the thumb screws on both battery retainers (item 1 in Figure 2) and rotate the
retainers so that the battery can be inserted into the base compartment.
3.
Slide the battery into the base compartment.
4.
Rotate the battery retainers so that the retainers hold the battery in its compartment
and tighten the thumbscrews.
5.
Connect the battery cable connector to the rear power input connector on the bottom-
right of the LRAD-100X (item 2 in Figure 2).
1
2
1