This device is intended only for OEM integrators under the
following conditions:
1)
The antenna must be installed such that 20 cm is
maintained between the antenna and users, and
2) The transmitter module may not be co-located with any
other transmitter or antenna, and
3) The antenna should be integral if the end device is intended
to be operated in 5.15 ~ 5.25GHz frequency range.
As long as 3 conditions above are met, further transmitter test
will not be required. However, the OEM integrator is still
responsible for testing their end-product for any additional
compliance requirements required with this module installed (for
example, digital device emissions, PC peripheral requirements,
etc.).
IMPORTANT NOTE:
In the event that these conditions can not
be met (for example certain laptop configurations or co-location
with another transmitter), then the FCC authorization is no
longer considered valid and the FCC ID can not be used on the
final product. In these circumstances, the OEM integrator will be
responsible for re-evaluating the end product (including the
transmitter) and obtaining a separate FCC authorization.
End Product Labeling
This transmitter module is authorized only for use in device
where the antenna may be installed such that 20 cm may be
maintained between the antenna and users (for example :
Access point, Router… mobile device.). The final end product
must be labeled in a visible area with the following: “Contains
TX FCC ID: MXF-M950606AG”.
Manual Information That Must be Included
The OEM integrator has to be aware not to provide information
to the end user regarding how to install or remove this RF
module in the users manual of the end product which integrate
this module.
The users manual for end users must include the following
information in a prominent location “ IMPORTANT NOTE: To
comply with FCC RF exposure compliance requirements, the
antenna used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons and must
not be co-located or operating in conjunction with any other
antenna or transmitter”.
If the end product integrating this module is going to be
operated in 5.15 ~ 5.25GHz frequency range, the warning
statement in the user manual of the end product should include
the restriction of operating this device in indoor could void the
user’s authority to operate the equipment.
