User guide – Plotter Flexipen 120/165
Plan
7
Chapter 4:
Control panel
LED LED
(green/red) (red)
• Display:
The display (1) shows the current state of the plotter:
LEAVE
: in this state you can move the printing head (dolly) on the left/right side or you
can move up/down the paper feed reels (using up, down, left, right key).
CONNECT
: in this state the plotter is ready to plot, and now you can change the
writing speed and the pen pressure.
In this state you can see on the display the writing speed and the pen pressure.
• Keys:
The
Off/On
key (2): the plotter will switch between the status of offline (LEAVE-
green light) and online (CONNECT-red light) if this key is pressed.
The
Pause
key (3): when plotting, if pause is needed press “Pause” key, the
plotting will stop immediately and will resume after press the key again.
Do not remove the printing head (dolly) when the plotter is in the Pause state.
The
Location
key (4): after moving the pen dolly and paper using the direction
keys, press the Location key to set the current point as starting point.
If you press this key the plotter will pass automatically in the CONNECT state,
and it waits for the computer command.
The
Test
key (5): by pressing this key the plotter will automatically create a
drawing. Thus you may verify that the plotter works properly.
The
Reset
key (6): when plotting, if current operation needs to be terminated,
and reset to original status, you can press the
Reset
key to terminate the program.
After you reset the plotter you must send one more time the files to be plotted.
The
P-
key
(7) has the following functions:
In LEAVE state: moves to the right side the printing head (dolly);
In CONNECT state: declines pen pressure (the decreasing pen pressure value
is
shown on display).
