ATTENTION
!
CAUTION
Non compliance to this instruction could result in serious damage to the
vehicle and to the alarm system.
Non compliance to this instruction may cause damage or operational
failures to the alarm system.
USER MANUAL
1.0 - INTRODUCTORY NOTE
Dear customer,
This self-powered alarm system is designed and manufactured in Italy
specifically for 2-wheeled vehicles. It is supplied with 2 remote controls and 1
touch key.
The alarm is factory programmed but features can be user-customized and
tilt/shock sensor sensitivity adjusted (see par. 26.0).
Please read the present manual carefully to familiarize yourself fully with the
alarm features and operating procedures and do keep it handy for future
reference.
2.0 - ALARM SYSTEM CONTROL DEVICES
The remote controls and the touch key are used to operate the alarm system. A
PIN code can be used to emergency override the system should the other devices
be lost or inoperative.
Override PIN code is entered by means of the vehicle ignition key (see chapter 8.0).
Button 1
LED
indicator
Button 2
Button 1
(textured):
Button 2
(smooth):
• Alarm system arming/disarming.
• Anti-hijack activation.
• Hazard flashers activation.
• Anti-hijack activation.
• Panic alarm activation/deactivation.
• Siren silencing during an alarm.
• Siren exclusion when arming.
• Tilt sensor exclusion.
The following signal words are included in the present manual to emphasize
important instructions and to alert the user/installer to potential hazards:
PAGE 3
PAGE 4
2.1 - REMOTE CONTROL
The remote control has a low charge battery indicator that gives early warning
to avoid malfunctioning. When the batteries are low, the LED blink when a
button is pressed. Replace the batteries: weak batteries will prevent the
remote control from properly operating the alarm system.
2.2 - TOUCH KEY
The touch key can be used in case your remote control is lost or not working.
By touching the key to its receptacle you can arm/disarm the system and
enable/disable the anti-hijack feature (if configured).
The touch receptacle incorporates a LED warning light that serves as both a
system status indicator and a visual theft deterrent.
Touch Key
Touch
Key
Positioning examples
The remote control has 2 buttons that activate several functions based on the
alarm configuration:
The 954N alarm system cannot be paired with transponder
TAG 908.
