CAUTION
7.0 - PIN CODE OVERRIDE
If you cannot disarm the system from the remote controls because they are lost
or broken or batteries are flat, you will be able to disarm the system by using the
PIN override procedure.
For security reasons, we recommend that you change the 4-digit PIN code
from the factory setting 1-1-1-1 (par. 9.0).
Trigger an alarm condition. After the warning signals, the status LED will
turn ON steady for approx. 5 sec.
To override the system:
While the LED is ON, cycle ignition key ON and then OFF
!
!
.
If ignition key stays in the ON position for more than 5 sec., the system will
interpret the situation as a theft attempt and trigger another alarm.
!
!
!
!
The status LED will turn OFF to confirm the system is in override mode.
4 sec. after the LED has powered OFF, there will be a
.
Count the number of flashes and, at the number of flashes that equals the
PIN 1st digit, cycle ignition key ON and OFF to confirm the entered digit.
After 4 seconds,
.
When the number of flashes equals that of the 2nd digit, cycle ignition key
ON and OFF to confirm the entered digit.
Repeat the above steps for the remaining two digits.
If the code has been entered correctly, the system will disarm and signal the
last cause of alarm (par. 3.11, “System disarming with alarm memory .
!
!
!
there will be another sequence of LED flashes
sequence of 9 LED
flashes
”)
If the LED blinks more than 9 times, the procedure will be invalidated and
considered a theft attempt.
CAUTION
PAGE 11
PAGE 12
8.0 - PIN CODE OVERRIDE EXAMPLE
To help you understand the override procedure by PIN code, here below is a
step-by-step example entering PIN code “2-3-4-1”.
After the alarm warnings are over, the status LED will turn ON steady for
approx. 5 sec. While the LED is ON, cycle ignition key ON and OFF; the
LED will go OFF to confirm the system is in PIN override mode.
After 4 sec. the LED will flash 9 times in sequence. Count the number of
flashes
equals that of the 1st digit
.
After 4 sec., there will be another sequence of LED flashes. Cycle ignition
key ON and OFF after the 3rd blink (PIN code 2nd digit “3”).
and cycle ignition key ON and OFF when the number of flashes
(in this case “2”)
Arm the system. After the arming delay, trigger an alarm condition.
Repeat the above steps for the remaining two digits (”
).
4” and “1”
Key “ON”
Key “OFF”
Alarm condition
Key
“OFF”
Key
N
“O ”
LED ON
approx. 5”
L
OFF to
confirm
override mode
ED
First digit: “2”
Second digit: “3”
“ON” “OFF”
4 Sec.
4 Sec.
4 Sec
.
4 Sec
.
Third digit: “4”
Fourth
digit: “1”
If the PIN code has been entered correctly, the alarm system will disarm
and signal the last cause of alarm (see par. 3.11).
“ON”
“ON”
“ON”
“OFF”
“OFF”
“OFF”
If the LED blinks more than 9 times, the procedure will be invalidated and
considered a theft attempt.
