Use the supplied tie
(13) or bolts (3) to
secure the control units
to the front bumper.
1
1
km/h
+12V
1
1
8.0 - CONNECTIONS
Check the wireless communication and the length of the cables before proceeding with
the final positioning of the accessories.
!
!
!
!
!
Install the control unit (4) in the front bumper away from heat sources.
Connect the sensors (1) and route the power supply cable inside the engine compartment or the
vehicle cabin.
Fix the display (2)
.
Connect the BLACK-BLUE wire of the control unit (4) to positive or to positive under key.
inside the vehicle cabin, in a dry place, away from eventual water infiltrations and
heat sources where it can easily be seen during the parking and reversing manoeuvers
!
!
!
!
!
Connect the BROWN wire of the front control unit (4) to the metal frame of the vehicle (ground).
(Optional) connect the BLACK-YELLOW wire of the control unit (4) or of the display (2) to the
o
of the vehicle (
).
Connect the BLACK-BLUE wire of the display (2) to the positive under key of the vehicle.
Connect the BROWN wire of the display (2) to the metal frame of the vehicle (ground).
Insert the 3-way connector in the display.
dometer signal
see “setting of parameter” to program the control unit or the display
and to adjust the pulses
If the power supply wire of the control unit is connected to a permanent positive, before
you start making the connection, read the instructions for pairing the control units with
the display.
!
9
7
8
14
Clean thoroughly the plastic brackets (7 or 8) and around the holes, apply “PRIMER”
(14), let dry for at least one minute and then proceed as follows.
!
7
8
PRIMER
3M
4298UV
Snap the sensor in the bracket
or snap bracket
n hole from outer part of bumper and
then insert sensor
In both cases position the plastic brackets so that the
connector of the sensor comes out horizontally
(7 or 8), peel off the
protective film from the adhesive and apply it to the bracket
(10) i
.
.
+18°C
1
BROWN
NO
YES
10
11
INSTALLER MANUAL - PAGE 09
PAGE 08 - INSTALLER MANUAL
