PAGE 06 - USER MANUAL
INSTALLER MANUAL - PAGE 07
S
.
ETTING OF OVERSPEED INDICATOR,
SCROLLING AND SETTING OF FUNCTIONS
ACTIVATION/DEACTIVATION OF SENSORS,
TURNING OFF OVERSPEED INDICATOR,
SCROLLING AND SETTING OF FUNCTIONS.
On every button press, the sensors will be
activated/deactivated.
The upward arrow icon will be displayed when
the sensors are activated.
SENSORS
DEACTIVATED
INDICATION ICON.
SENSORS
ACTIVATED
INDICATION ICON.
DISTANCE OF OBSTACLE
INDICATOR
PARAMETER.
STATUS (F or C) AND
SETTING OF PARAMETER
.
.
VEHICLE SPEED.
SOFTWARE VERSION.
FRONT SENSORS
DETECTION ZONES
ICONS.
S
.
ETTING MODE
CONTROL UNITS/DISPLAY
SIGNAL RECEPTION TEST.
RF DISTURBANCES.
AUDIBLE WARNINGS
ON/OFF ICON.
“STOP” ZONE ICON.
5.0 - DISPLAY
The following icons will be displayed according to operations.
This procedure can only be done if the relative cable of the display wiring is connected
to the odometric signal of the vehicle; check with your installer.
6.0 - SETTING OF OVERSPEED AUDIBLE ALERT
!
!
!
!
Turn the ignition “ON”.
12.0 and 13.0),
14, select value 2
and
.
Turn ignition key “OFF” then “ON” and increse speed.
.
.
Enter in the programming mode (see chapters
select parameter
set it by keeping one of the two display buttons pressed for about 3 sec.; by activating this
function the display and the speed value will light up every time speed exceeds 15 km/h
Look at the speed displayed; when the required threshold is reached to set the overspeed audible
alert, press the right-hand display button
A series of audible signals will now sound every time the vehicle exceeds the registered speed.
To deactivate this function press the left-hand display button when speed exceeds 15km/h; an
audible signal will indicate deactivation.
To reactivate this function and set another threshold, press the right-hand side button (even if the
speed is higher than the one actually set, the system will register this last value)
!
!
!
Choose the suitable type of
acket and mark the center of the holes to drill.
For brackets “7” drill holes with a 18mm diameter, for brackets “8” drill holes with a 22mm and for
brackets “10” drill holes with a 24mm diameter.
Sensors and plastic brackets can be painted to match the color of your bumpers.
plastic br
7
8
1
1
1
+
+
+
4 x
18
22
10
24
H = 400 - 500 mm
H
100
100
320
320
INSTALLER MANUAL
7.0 - INSTALLATION OF SENSORS
To install the sensors on a metal bumper, you must use appropriate adapters (
.
not
supplied)
!
Before drilling, inspect behind the bumper to check for any possible obstruction such as
iron struts and, in any case, be careful to avoid damaging parts behind the bumper.
!
H = 500 mm H = 650 mm
H = 350 mm
+10°
0°
-10°
10
8
7
+10°
+0°
1
1
