PAGE 06 - INSTALLER MANUAL
INSTALLER MANUAL - PAGE 07
12
6
6a
8
PRIMER
3M
4298UV
8
9
7
10
1
+18°C
á
Install the BLUE sensors on the outer edges of the rear bumper.
Install the BLACK sensors on the center of the rear bumper.
BLACK
2
BLUE
6.0 - CONNECTIONS
Check the length of the cables before proceeding with the final positioning of the
accessories.
!
!
!
!
!
!
!
!
!
Position the control unit (4) in the luggage compartment, in a dry place, away from eventual water
infiltrations and heat sources.
Run the cables along the rear bumper and route them inside the luggage compartment.
Fix the display (3) inside the vehicle cabin, a dry place, away from eventual water infiltrations and
heat sources
Connect the BLACK-BLUE wire of the control unit wiring harness (5) to the positive of the reverse
light.
Connect the BROWN wire to the metal frame of the vehicle (ground).
Plug the display (3) terminals with the BROWN, RED-YELLOW and WHITE-BLUE wires to the
control unit connector (5), respectively in positions 1, 6 and 13.
(Optional) connect the GREY-RED wire for the “mute” feature to the corresponding wire of the car
radio preset for this feature.
Plug the 24-way connector of the front sensors wiring into the corresponding connector of the
control unit (4).
where you can easily see it while parking.
NO
YES
1
2
2
1
4
MUTE
R
3
Clean thoroughly the plastic brackets (6 or 6a) and around the holes, apply “PRIMER”
(12), let dry for at least one minute and then proceed as follows.
!
Place the sensor
in the bracket and
remove the
adhesive
protection.
Put the sensors in the
hole and snap-in the
bracket.
Position the bracket so
that the connector of
the sensor comes out
horizontally.
