PAGE
- USER MANUAL
04
INSTALLER MANUAL - PAGE 05
4.0 - TROUBLESHOOTING GUIDE
4.1 - LOW POWER SUPPLY SIGNAL
4.2 - FAULTY SENSORS
If, when the control unit is turned on, the battery level is too low to guarantee the accuracy of the
system, the buzzer will sound to indicate activation but there will be no video display.
This will inform the user that ALL the sensors are deactivated.
The driver will therefore know that he will have to do without the parking sensors.
If, when the reverse gear is engaged, one of the sensors turns out to be inoperative or not connected,
you will hear 4 deep-toned beeps and 1 long high-pitched beep.
The display will indicate the deactivation of the beeping, the number of the inoperative sensor, the
detection zone and the LED will be ON.
INSTALLER MANUAL
5.0 - INSTALLATION OF SENSORS
To install the sensors on a metal bumper, you must use appropriate adapters (not
supplied).
!
6
6a
2
2
1
1
+
+
4 x
18
22
9
2
1
+
24
8
H
MAX
H = 500 mm
H = 500 mm
H = 650 mm
H = 650 mm
H = 350 mm
+10°
0°
-10°
9
8
6a
6
1
2
1
+10°
0°
2
Choose the suitable type of
acket and mark the center of the holes to drill.
For brackets “6” drill holes with a 18mm diameter, for brackets “6a” drill holes with a 22mm
diameter and for brackets “8” and “9” drill holes with a 24mm diameter.
Sensors and plastic brackets can be painted to match the color of your bumpers.
plastic br
250
600
250
600
If more than one sensor is inoperative, the number of the faulty sensors and the detection zone will be
alternatively displayed on the main control unit.
Ice on sensors
Sensors mounted too low
Back part of sensors in contact with frame
Sensors detect external spare wheel
POSSIBLE CAUSE
Clean the sensors
Use the angle brackets (6a or 9) to tilt axe of sensors
upwards
Create a separation between the sensors and the vehicle
Modify the setting of parameter 10
SOLUTION
4.3 - OTHERS
How to remove a
terminal with the
adequate tool (13).
13
13
13
Sensor 1
inoperative
Sensor 4
inoperative
One single faulty sensor alters the correct functioning of the whole system.
Before drilling, inspect behind the bumper to check for any possible obstruction such as
iron struts and, in any case, be careful to avoid damaging parts behind the bumper.
!
