Gema UA05, Руководство по эксплуатации, Страница: 29 / 56

Rev. 00 09/22
UA05 Start-up
•
29
Start-up
Preparation for start-up
ATTENTION
Incorrect setting of the stroke limit will cause damages to the axis,
to the booth or to the applicators
► Before connecting or switching on the axis, read carefully these
operating instructions!
► Before the axis is put into operation, the stroke limit must be set!
► See the user manual of the axis control unit!
General information
WARNING
Before start-up works are done, make certain that nobody can
switch on the axis!
► Switch off and lock the mains switch!
Before starting up, check the following:
–
Check the gun holder and hose holder if they are firmly fitted. Mount
the gun holder in such a way that they do not hit the bottom of the
booth slots on start-up and cause damage
–
Lay out the cables and hoses in such a way that even at the highest
stroke no strain can
–
Check the grounding of the guns and hose carriers
–
Check if the front and the rear reversing point of the carriage are set
correctly. The stroke length of the axis must be in the range of the
booth opening (collision danger!)
–
Make sure that the automatic guns cannot collide with the work
pieces (incorrectly adjusted stroke parameters on the axis control
unit)