V
03/17
OptiFlex A2 (AS08)
Safety
•
5
Safety
General information
This chapter sets out the fundamental safety regulations that must be
followed by the user and third parties using the OptiFlex A2 (AS08)
control system.
These safety regulations must be read and understood in full before the
OptiFlex A2 (AS08) control system is put into operation.
WARNING
Working without operating instructions
Working without operating instructions or with individual pages
from the operating instructions may result in damage to property
and personal injury if relevant safety information is not observed.
►
Before working with the device, organize the required documents
and read the section on "Safety regulations".
►
Work should only be carried out in accordance with the
instructions in the relevant documents.
►
Always work with the complete original document.
Intended use
–
This product is built to the latest specification and conforms to the
recognized technical safety regulations and is designed for the
normal application of powder coating.
–
Any other use is considered non-compliant. The manufacturer shall
not be liable for damage resulting from such use; the user bears sole
responsibility for such actions. If this product is to be used for other
purposes or other substances outside of our guidelines then Gema
Switzerland GmbH should be consulted.
–
Observance of the operating, service and maintenance instructions
specified by the manufacturer is also part of conformity of use. This
product should only be used, maintained and started up by trained
personnel, who are informed about and are familiar with the possible
hazards involved.
–
Start-up (i.e. the execution of intended operational tasks) is
forbidden until it has been established that this product has been set
