Rev. 01 08/20
44
Operation
OptiStar All-in-One (CG22-C)
Powder output/powder hose correction
The settings in the following example are carried out for each
gun individually!
Powder output corrections are made at the first start-up, after a service
work, after the solution of application problems, or by using different hose
diameters!
It is recommended to create a table with input fields (see "Example table
for powder output/powder hose correction"), so that, if a possible system
reset takes place, an access to these data can take place.
Powder output correction
– procedure
1.
Set the total air
to
4,0
(Nm³/h).
2.
Set the powder output
to
00
(%)
3.
Select the submenu
Correction Values
in the
MAIN MENU
4.
Press
or
for switching to the corresponding display
5.
Check the correction value for minimum powder output
C0
, and set it
to
1.8
(Nm³/h) with the
or
keys if necessary
6.
. Check the correction value for maximum powder output
C1
, and
set it to
100
(%) if necessary
For the next steps a measuring bag is necessary, for weighing
the powder output.
– Do not forget to note the dead weight of the measuring bag.
7.
Put the measuring bag over the gun nozzle and fasten it. Switch on
the gun for 60 seconds
8.
After this time has elapsed, switch off the gun, remove the
measuring bag and weigh it. The powder output should be between
10-15 gr
9.
If no powder is expelled from the gun, return to the system
parameter mode and increase the minimum powder output value
C0
(range
0.5-3.0
Nm³/h)
10. If too much powder is expelled from the gun, return to the system
parameter mode and decrease the minimum powder output value
C0
(range
0.5-3.0
Nm³/h)
11. Repeat steps 7 and 8, until the powder output amounts to 10-15 g.
Annotate the adjusted minimum powder output value
C0
in the table
12. Press
key to quit the correction values mode.
The display switches to the
START
screen
Powder hose correction
– procedure
1.
Set the powder output
to
80
(%)
2.
Put the measuring bag over the gun nozzle and fasten it. Switch on
the gun for 60 seconds
Содержание CG22-C
