4
Gerhard Geiger GmbH & Co. KG | 100W1610
0315
V000
en
EN
EN
8. Programming the sun automatic function to a GEIGER
motor or an external radio receiver
I
The operation is to be performed during the 30 minutes after the
power supply has been switched on.
1.
Select the sun automatic channel ( ) with the channel
selection keys (
)
2.
In the near range press the UP ( ) or DOWN key ( )
for about 3 seconds until the motor confirms with an
audible signal (1x click-click).
3.
Hold the wall transmitter with the bottom side to the
power cable and press the UP ( ) or DOWN key ( )
for 1 second. The motor confirms with an audible signal
(1x click-click).
Then program the wall transmitter in the GEIGER sun/
wind sensor.
4.
Hold the bottom side of the wall transmitter on the left
side of the sun/wind sensor, press the UP or DOWN
key – the sun icon of the wall transmitter lights up –
until the red LED of the sun/wind sensor lights up.
9. Sun automatic
To enable / disable the automatic sun function, press the channel selection keys (
)
until the sun icon ( ) lights up.
The sun automatic function is activated with the UP key ( ) and deactivated with the
DOWN key ( ).
10.
Create a wall transmitter copy
If you want to create a copy of your wall transmitter with all its
functions (e.g. two identical wall transmitters for two persons),
please proceed as follows:
1.
Move both wall transmitters out of theirs holders.
2.
Use the same coding on the second transmitter (copy) as the
original one. The keys 7, 8 and 9 are not modified.
3.
Put the wall transmitters back on theirs supports.
This process allows you to create an unlimited number of
copies of the original wall transmitter.
230
V
On
Off
connect to
mains
1 x “click-click“
max. 15 cm
click-
clack
1
2
3
4
5
6
or
about 3 sec.
1 x
max. 15 cm
click-
clack
1
2
3
4
5
6
or
about 1 sec.
1 x
23
456
1
23
456
1
1
+ 0 -
23456789
CR2032
Individual
coding
Channel
selection
