Gehl R190, Руководство оператора

Страница: 84 / 130

80 50950106/AP0313
Refer to the Maintenance Interval chart (page 103) for change intervals. Refer to
the Replacement Parts chart (page 68) for filter part numbers. Refer to the
Engine Operator’s Manual for detailed engine information.
Checking Engine Mounting Hardware
All bolts that secure the engine mounting brackets to the engine and the loader
frame should be checked and re-torqued as necessary. Refer to the Torque Speci-
fications Chart (page 119) for torque information.
Allow hot engine and hydraulic system com-
ponents to cool before servicing.
Checking Engine Oil Level
Open engine cover (page 70), pull out the dipstick and check the oil level. Mark-
ings on the dipstick represent FULL and LOW (add oil) levels.
Changing Engine Oil and Filter
Note: For new units, the initial oil change should be after the first 50 hours.
Important: Always dispose of waste
lubricating oil according to local
regulations or take to a recycling
center for disposal; do not pour
onto the ground or down the drain.
The remote engine oil filter is
located behind the engine, above the
battery. Raise the engine cover and
lock open the rear grille to access
the oil filter (Figure 41).
Access for draining the engine oil is
located behind the left rear tire
(Figure 42).
To add new oil, open the engine
access cover. Remove the oil fill
cap and add the recommended type
and quantity of oil. Refer to the
Lubrication chart, page 73. Visually
inspect the remote oil drain hose for
damage or leaks.
Important: It is recommended that
the engine oil change occur after
every five engine DPF (diesel par-
ticulate filter) regenerations, if five
stationary regenerations occur
during the duration of the 250 hour
oil change interval. See page 44 for more information on the engine regeneration
process.
WARNING
Figure 41 Remote Engine Oil Filter
Figure 42 Remote Engine
Oil Drain Cap