Gehl R105 (EU), Руководство оператора

Страница: 84 / 118

80 50950260/AP1216
5. Fill the radiator fully and the recovery tank half full with the premixed
coolant.
6. Reinstall the radiator cap.
7. Run the engine until it is at operating temperature. Stop the engine and let it
cool. Check the coolant level. Add more coolant if required.
Chaincases
The chaincase contains the drive sprockets and drive chains. There are two plugs
in each chaincase. One is to drain the fluid and the other is to check the fluid
level. Refer to the
Maintenance Schedule chapter (page 97) for change intervals.
Refer to the Lubrication topic (page 65) for information on oil type and quantity.
Checking and Adding Oil
1. Park the loader on a level surface.
Stop the engine.
2. Remove the check plug from each
chaincase housing. If the oil can be
reached with the tip of your finger, the
oil level is adequate.
3. If the level is low, add fluid through
the check plug until the oil level
reaches the edge of the hole. Reinstall
the check plug.
Draining Oil
1. Raise the rear of the machine to aid in
draining the chaincases.
2. Remove the drain plug on each chain-
case and drain the oil into a suitable
container.
3. Reinstall and tighten the drain plugs.
4. Refill the chaincases at the check
plugs.
Seat and Restraint Bar
Switches
Electrical switches in the seat and restraint bar must be closed (operator sitting in
the seat and restraint bar lowered) to complete the circuit and start the engine.
Bucket Cutting Edge
The bucket cutting edge should be replaced when it is worn to within 1 in. (25 mm)
of the bucket body.
Figure 17 Check Plug
Figure 18 Right side drain plug
(left side same)