Gehl Dynalift 663, Руководство оператора

Страница: 46 / 72

NOTE:
For proper replacement procedures refer
to the engine manual for your machine.
After fuel filter replacement, bleed the air out of the
fuel system following the procedures in the engine
manual.
Fuel Bleeding Procedures
When the fuel filter is removed and replaced, or the
engine runs out of fuel, air must be bled from the sys-
tem. Refer to the engine manual relative to proper
bleeding procedures.
If the engine still will not start, consult your nearest
authorized engine dealer.
NOTE:
Only an authorized engine dealer can
perform WARRANTY Service on the engine.
Diesel Fuel Injectors
Whenever faulty or plugged injectors are indicated, see
your nearest authorized engine dealer.
Diesel Injection Pump Timing
Whenever injection pump timing, or other pump ser-
vice is indicated by abnormal engine operation, contact
your nearest engine dealer.
CHANGE ENGINE OIL & FILTER
Change the engine oil and filter using the following
procedure:
1. With the engine warm, remove the crankcase drain
plug. Some plugs are equipped with a magnet to gath-
er metal particles. Completely clean and flush away all
metallic filings from the plug and re-install it.
IMPORTANT:
DO NOT discharge onto ground.
Catch and dispose of per local waste disposal
regulations.
2. The engine oil filter should be changed at every oil
change interval. Remove and discard the throw away
filter canister. Wipe the gasket sealing area of the block
with a clean cloth.
NOTE:
Your OEM engine oil filters have special
by-pass valves built in. Use only genuine OEM
engine replacement filters.
3. Apply a thin coat of clean oil to the new oil filter
gasket and spin tighten. Refill the crankcase with new
oil. Follow specifications in the Lubrication chapter for
type and viscosity of new oil to put in.
4. After new oil has been added, run the engine at idle
speed until the oil pressure light is OFF. Check for
leaks at the filter and drain plug. Re-tighten only as
much as necessary to eliminate leakage.
CHECK THE BATTERY
The battery furnished with this machine is a 12 volt,
wet-cell battery.
Handling Battery Safely
The top of the battery must always be kept clean. Clean
the battery with a brush dipped in an alkaline solution
(ammonia or baking soda and water). After the foam-
ing has stopped, flush the top of the battery with clean
water. If the terminals and cable connection clamps are
corroded or have a buildup, disconnect the cables and
clean the terminals and clamps with the same alkaline
solution.
NOTE:
The battery in this machine is warranted
by the supplier. See the punch tag on the top of
the battery for warranty information.
WARNING
NEVER service the fuel system while smok-
ing, while near an open flame, or after the
engine has been operated and is hot.
WARNING
Escaping diesel fuel under pressure can have
sufficient force to penetrate the skin. Before
applying pressure to the fuel system, BE
SURE all connections are tight and lines and
hoses are NOT damaged. Use a piece of wood
or cardboard to search for suspected leaks. If
injured by escaping fuel, see a doctor familiar
with this type of injury at once or gangrene
may result.
907879/AP1198
44
PRINTED IN U.S.A.
Courtesy of CraneMarket.com