2
1
Intended Use
The
ABAC
Motor Blower SG 90 E (electronic) – named in this manual also as Motor
Blower or simply Blower – is intended to be used in connection with the
ABAC
Low
Pressure Spray Guns PN 2 or PN 5 to spray and apply paints and lacquers. For
spraying you may use materials approved by paint manufacturers for High Volume Low
Pressure (HVLP) air-spraying technique application. These are for instance:
·
Patina paints, two-component-paints, synthetic resin alkyd paints, acrylic and
dispersion paints, colour effect paints, insulation / inflammation protection, sprayable
wax materials.
Any use of the Motor Blower different from described in this manual is prohibited.
Identification number of SG 2500 Motor Blower is BJ 370 000 0021 (100 V),
BJ 370 000 0041 (115 V), BJ 370 000 0002 (230 V).
Always observe and comply with all processing instructions and safety notes provided
by material manufacturers as well the prescriptions of this operating manual.
In any case, only paints and solvents with a flash point above 21
°
C = 70
°
F may be used
for spraying!
The
ABAC
Motor Blower SG 90 E is designed to be operated with PN 2 / PN 2A and
PN 5
ABAC
Spray Guns.
It is prohibited to use the
ABAC
Motor Blower SG 90 E together with
spray guns with intermittent air supply (for example, with
ABAC
PN 1 / PN 1A Spray Guns)! In case of their co-use, when air supply
will be stopped for spraying (by trigger release), motor overheating
and unit breakdown may occur due to air backflow and
accumulation.
Ambient temperature range for equipment operation is from 0
°
С
to +45
°
С
, relative
humidity must not exceed 80%. Conditions of transportation and storage see Section 5.
