5
SENDER PANEL DESCRIPTIONS
1. Standby Button
Pressing this will put the sending unit in standby mode. The unit will not
transfer any information to the receiving unit in this mode. To release
standby mode, simply press the button again.
2. Ethernet Input Port
Connects to the Ethernet source (i.e a router, computer, or Internet
connection) via a standard network cable.
3. Security/Reset Button
Pressing this button for 2 seconds will activate the Automatic Security
Confi guration (please see page 17). Pressing this button for more than 10
seconds will perform a factory reset.
4. AC Power Cable Input
Input for the supplied AC power cable.
5. Coaxial
Output
Coaxial output to link the sending and receiving units together. This
connector will support RG-6 and RG-59 cables.
6. LAN LED
This LED will activate when a connection to a valid Ethernet source is
established. It will blink when activity is detected to signify that data is
actively being traffi cked to and from the receiver.
7. Link LED
This LED will activate once a link has been established between the sending
and receiving units. It will blink when activity is detected to signify that data is
actively being traffi cked.
8. Power LED
This LED will activate once the included power supply is properly connected.
