7
1 Equalization
Adjustment
This Trim Pot is used to adjust the equalization that compensates for the
differences that are present in cable qualities and skews. Automatic equalization
(Auto EQ) is available and is set to on by default. Cable lengths that exceed 130
feet (40 meters) should not use Auto EQ.
2
Infrared (IR) Receiver
This IR receiver will relay IR commands from the receiving unit to the sending
unit for output to a IR transmitter (blaster) on a IR controllable device.
3 HDMI
Input
This input will accept one HDMI source device that will be extended to the
receiver’s location.
4
LED Power Indicator
This LED will become active once the included 5V DC power supply is properly
connected between the sender and an open wall power socket.
5
Video CAT-5 Port
This port is used to connect the sending and receiving units together for Video
traffi c. Use a CAT-5, CAT-5e or CAT-6 cable. When fi eld terminating cable
please adhere to the TIA/EIA-568-B specifi cation (page 12).
6
DDC CAT-5 Port
This port is used to connect the sending and receiving units together for DDC
traffi c. Use a CAT-5, CAT-5e or CAT-6 cable. When fi eld terminating cable
please adhere to the TIA/EIA-568-B specifi cation (page 12).
7
Infrared (IR) Receiver Extension Port
This port will accept an optionally purchased IR extension cable (Gefen part#
EXT-RMT-EXTIR). This is useful for installations where the IR receiver, located
on the front panel (Item 2 on this page), is not in line-of-sight with the IR remote
control used to relay commands to the device at the sender’s location.
8
5V DC Power Receptacle
This receptacle will require power from the included 5V DC power supply for
proper operation.
RECEIVER PANEL DESCRIPTIONS
